User manual AEG-ELECTROLUX PN 11 E

[. . . ] Be sure that you understand their meaning before use. . . . . . . . . . . . . . . . . . . . Read instruction manual. . . . . . . . . . . . . . . . . . . . DOUBLE INSULATION . . . . . . . . . . . . . . . . . . Only for EU countries Do not dispose of electric equipment together with household waste material!In observance of European Directive 2002/96/EC on waste electric and electronic equipment and its implementation in accordance with national law, electric equipment that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. [. . . ] Power tools are dangerous in the hands of untrained users. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the power tools operation. If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. Use the power tool, accessories and tool bits etc. in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. ADDITIONAL SAFETY RULES FOR TOOL 1. Exposure to noise can cause hearing loss. Switch trigger · · 006308 OFF 1 When using the tool in the hammering mode for a long time, the slide switch is available. To start the tool, push the "I (ON)" side of the switch lever. To stop the tool, push the "O (OFF)" side of the switch lever. ON 1. Switch lever 5 006334 Speed change The revolutions and blows per minute can be adjusted just by turning the adjusting dial. The dial is marked 1 (lowest speed) to 5 (full speed). Refer to the table below for the relationship between the number settings on the adjusting dial and the revolutions/blows per minute. 006335 1 Number on adjusting dial 5 4 3 2 1 Revolutions per minute 480 440 360 270 230 Blows per minute 2, 750 2, 550 2, 050 1, 550 1, 350 1. Adjusting dial · · CAUTION: If the tool is operated continuously at low speeds for a long time, the motor will get overloaded, resulting in tool malfunction. The speed adjusting dial can be turned only as far as 5 and back to 1. Do not force it past 5 or 1, or the speed adjusting function may no longer work. Selecting the action mode 006309 HR4001C PN 11 E Rotation with hammering For drilling in concrete, masonry, etc. , depress the lock button and rotate the change lever so that the pointer points to the symbol. Use a tungsten-carbide tipped bit. 2 1 3 1. Lock button 006310 HR4011C 2 1 3 1. [. . . ] Turn the tool on and apply slight pressure on the tool so that the tool will not bounce around, uncontrolled. Pressing very hard on the tool will not increase the efficiency. 11 MAINTENANCE · CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Lubrication CAUTION: This servicing should be performed by Makita Authorized or Factory Service Centers only. · 006326 1 This tool requires no hourly or daily lubrication because it has a greasepacked lubrication system. Lubricate the tool every time the carbon brushes are replaced. Run the tool for several minutes to warm it up. [. . . ]