User manual AEG-ELECTROLUX RA0450W

[. . . ] There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible content loss. Parts which heat up should not be exposed. Wherever possible the back of the product should be close to a wall but leaving the required distance for ventilation as stated in the installation instructions. [. . . ] Finally wipe over with a cloth rinsed in warm water only, and dry with a clean cloth. Do not wash any plastic parts in water that is more than hand warm, and do not expose them to dry heat. The outside of the cabinet should be wiped down regularly with a clean, damp cloth. NEVER USE STRONG CHEMICALS OR ABRASIVE CLEANING MATERIALS ON ANY PART OF THE CABINET. 3. Ventilation must be provided as shown in alternatives A, B, C or D (fig 2-3) 4. The ventilation duct must at least measure 105mm x the width of the refrigerator 5. Only the entire cooling unit must project into the duct as shown 6. Air passing through the duct must not be preheated by any source of heat 7. Ventilation grills, if used, must have openings of at least 200cm2 each During installation, please ensure the mains plug is accessible at all times. 4. Positioning the appliance When first using this refrigerator please consider the following points: ENSURE REFRIGERATOR IS LEVEL THE PIPEWORK AT THE BACK GETS HOT IN USE THE REFRIGERATOR HAS NO 'MOTOR' AND IS THEREFORE VIRTUALLY SILENT ALLOW AT LEAST 3 HRS. FOR SIGNS OF COOLING During the refrigeration process, the appliance gives off heat from the condenser (under the upper part of the rear cover) into the surrounding air. Useful suggestion Do not overfill the appliance. It is advisable to leave some space between the products in the cabinet to ensure efficient and even cooling. If the shelves are packed too tightly there may be unacceptable temperature variations. 7. 5) Refer to the separate instruction leaflet supplied with the thermometer. The thermometer can be stood up using the attached stand or alternatively it can be fixed to the refrigerator door, in which case the sensor wire should be arranged so that it is not stretched or damaged when the door is opened. The temperature sensor is located inside the refrigerator below the bottom shelf. The display will then show the current, maximum and minimum temperature inside the refrigerator. After the first pull down of the refrigerator (allow four hours) please make a "reset" on the thermometer 6 GB 9. Defrosting, cleaning and maintenance Frost will gradually form on the cooling surfaces and it must not be allowed to become too thick since it acts as an insulator and interferes with the cooling. A semi-automatic defrosting model device can be identified by the push -button in the centre of the thermostat dial. 6) To defrost, push in the button in the centre of the thermostat dial but do not turn the dial to another position-leave it at its usual setting. [. . . ] In the event of a fault developing, contact your nearest Service Centre-see local telephone directory. Putting into operation Technical data: Model Type Gross volume Mains operation Input Energy consumption Climate class Refrigerant RA 122 H MF20-60 31 litre 220 - 240V (AC) 75W 1. 3 kWh/24h N 245g NH3 +H2O RA 212 H MF20-60 60 litre 220 - 240V (AC) 95W 1. 4 kWh/24h N 525g NH3 +H2O 11. 1 Connecting to electrical mains The appliance may only be operated from nominal voltage mains as shown on the data plate. The appliance mains plug may be connected to a mains socket earthed in accordance with regulations. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ]