User manual AEG-ELECTROLUX RC1070-2

[. . . ] Visit our website for: Get usage advice, brochures, trouble shooter, service information: www. aeg. com Register your product for better service: www. aeg. com/productregistration Buy Accessories, Consumables and Original spare parts for your appliance: www. aeg. com/shop CUSTOMER CARE AND SERVICE We recommend the use of original spare parts. When contacting Service, ensure that you have the following data available. The information can be found on the rating plate. Warning / Caution-Safety information General information and tips Environmental information Subject to change without notice. ENGLISH 3 1. [. . . ] Put the product in the compartment before you start the programme. This is the maximum level for the quantity of liquid additives. Flap for powder or liquid detergent Turn it (up or down) in the correct position to use powder or liquid detergent. ENGLISH 15 Always obey the instructions that you find on the packaging of the detergent products. Check the position of the flap 1. Pull out the detergent dispenser until it stops. Press the lever down to remove the dispenser. 3. To use powder detergent, turn the flap up. 4. To use liquid detergent, turn the flap down. With the flap in the position DOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid detergent than the limit showed in the flap. – Do not set the delay start function. 5. 6. Measure out the detergent and the fabric conditioner. Carefully close the detergent dispenser. Make sure that the flap does not cause a blockage when you close the drawer. 2. 9. 3 Setting and starting the programme 1. Turn the programme knob. The related programme indicator comes on. The indicator of button 4 flashes with red colour. When the countdown is completed, the programme starts automatically. Before you press button 4 to start the appliance, you can cancel or change the set of the delay start. 2. ENGLISH 17 When you activate the appliance again, the display show the end of the last set programme. Turn the programme knob to set a new cycle. • Remove the laundry from the appliance. • Keep the door ajar, to prevent mildew and odours. The washing programme is completed, but there is water in the drum: – The drum turns regularly to prevent the creases in the laundry. – The door stays locked. – You must drain the water to open the door. If necessary, decrease the spin speed. 2. Press the Start/Pause button 4 . When the programme is completed and the door lock symbol goes off, you can open the door 4. The appliance drain and spin automatically after approximately 18 hours. 10. HINTS AND TIPS 10. 1 The laundry load • Divide the laundry in: white, coloured, synthetics, delicates and wool. [. . . ] Pull up the appliance in vertical position. 1 2 ENGLISH 27 9. Remove the power supply cable and the drain hose from the hose holders. 10. Use the key supplied with the appliance. 11. Put the plastic caps in the holes. You can find these caps in the user manual bag. – We recommend that you keep the packaging and the transit bolts for when you move the appliance. – If the appliance is delivered in the winter months when there are minus temperatures. [. . . ]