User manual AEG-ELECTROLUX RC1080-2

[. . . ] Visit our website for: Get usage advice, brochures, trouble shooter, service information: www. aeg. com Register your product for better service: www. aeg. com/productregistration Buy Accessories, Consumables and Original spare parts for your appliance: www. aeg. com/shop CUSTOMER CARE AND SERVICE We recommend the use of original spare parts. When contacting Service, ensure that you have the following data available. The information can be found on the rating plate. Warning / Caution-Safety information General information and tips Environmental information Subject to change without notice. ENGLISH 3 1. [. . . ] The detergent compartment for the washing phase. If you use a liquid detergent, put it immediately before you start the programme. Liquid additives compartment (fabric conditioner, starch). Put the product in the compartment before you start the programme. This is the maximum level for the quantity of liquid additives. ENGLISH 15 The compartment for the stain remover. Put the product in the compartment and set the stain function before you start the programme. Flap for powder or liquid detergent Turn it (up or down) in the correct position to use powder or liquid detergent. Always obey the instructions that you find on the packaging of the detergent products. Check the position of the flap 1. Pull out the detergent dispenser until it stops. Press the lever down to remove the dispenser. 3. To use powder detergent, turn the flap up. 4. To use liquid detergent, turn the flap down. With the flap in the position DOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid detergent than the limit showed in the flap. Close the appliance door and press button 4 . The programme or the delay start continues. If the temperature and level of the water in the drum are too high, the door lock symbol stays on and you cannot open the door. To open the door do the steps that follow: 1. If you deactivate the appliance, it is necessary to set the programme again. When you activate the appliance again, the display show the end of the last set programme. Turn the programme knob to set a new cycle. • Remove the laundry from the appliance. • Keep the door ajar, to prevent mildew and odours. The washing programme is completed, but there is water in the drum: – The drum turns regularly to prevent the creases in the laundry. – You must drain the water to open the door. 1. 2. To drain the water: If necessary, decrease the spin speed. 8. 10 At the end of the programme • The appliance stops automatically. [. . . ] 8. Remove the polystyrene protection from the bottom. Pull up the appliance in vertical position. 1 2 9. Remove the power supply cable and the drain hose from the hose holders. 10. Use the key supplied with the appliance. 11. Put the plastic caps in the holes. You can find these caps in the user manual bag. 28 www. aeg. com WARNING! [. . . ]