User manual AEG-ELECTROLUX RC3000EGP

[. . . ] Provide ample ventilation especially when sleeping. Do not use this refrigerator in unventilated structures to avoid endangering your life. Provide additional ventilation for any additional fuel burning appliances and additional occupants. 2 CONTENT S 1. Unpacking View of the appliance Cleaning Installation Using the appliance 5. 1. [. . . ] Liquid gas operation Connection to the gas cylinder is described in sections 11. 3. After opening the gas cylinder valve, push the safety gas valve down (Figure 4) and set it to the large flame symbol, holding it down for about 10 seconds. Keep the button pressed down and press the piezo-igniting button (marked with a star) several times one after the other. If the flame does not ignite, repeat the process. (Air in the appliance gas line prior to connection to the gas cylinder must be evacuated. Only then can the gas be lit. ) Ignition of the flame can be verified through the flameview opening (Figure 5). After you have got the flame keep the safety gas valve down another 20 seconds. Figure 4. Figure 5. 6 If, for any reason, the gas flame extinguishes, the flame safety device is working automatically and shuts off gas supply. While the button is pushed, this device is temporary inoperative. After finishing the gas operation the gas supply is to be turned off. 6. Mounting the wheels The wheel set, found inside the appliance, consists of the following parts: 2 wheels 1 axle 1 axle-retaining screw 1 pull handle 1 handle fastener 2 screws for the pull handle First mount the two wheels on the axle. To do so, press in the spring located on the wheel (Figure 6); then release the spring, pushing the wheel onto the axle. It can be felt when the spring jumps into place and it is not possible to pull the wheel from the axle. After mounting the wheels, fasten the axle to the bottom of the housing. To do so, turn the appliance upside down (while empty) and fasten the axle with the retaining screw (Figure 7). Figure 6. Figure 7. To mount the pull handle, turn the appliance (while empty) on its end. Position the pull handle below the handle fastener, so that its smooth surface is on the outside. Screw the handle fastener to the chassis using both screws (Figure 8). Snap the pull handle into the fastener groove, folding it down beside the chassis. In this position, it acts as a leg when the appliance is in operation. If you wish to pull the appliance on wheels, make sure no power source is connected. Then straighten up the pull handle and pull the appliance to its new location. When loading onto a vehicle, the wheels and handle are removed in reverse order (if required for better use of space). The appliance must be empty to carry out these processes. Figure 8. 7 7. [. . . ] This refrigerator is designed for self-contained fuel cylinder of not more than 75 cubic inches (2 ½ pounds nominal water capacity). The cylinder(s) must be constructed and marked in accordance with the specifications for LP-gas cylinders of the U. S. Department of Transportation (DOT), DOT SPEC. 89 (49CFR 178. 65), in Canada, with the ministry of transport and communication. [. . . ]