User manual AEG-ELECTROLUX RGE400

[. . . ] This product is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the product. Any electrical work required to install this appliance should be carried out by a qualified electrician. It is dangerous to alter the specifications or modify this product in any way. [. . . ] General guide to fitting any plug Ensure the lengths of wire inside the plug are prepared correctly. Connections should be firmly made after all conductor strands are entered into the terminal posts. When preparing the cable ends, take care not to damage the outer sheath or the insulation surrounding the inner conductors. Replace the top cover of the plug and secure. Other versions Your refrigerator has a 3-wire mains lead which is intended for connection to a 3-pin plug and a properly earthed socket outlet. IMPORTANT: The wires in the mains lead of this appliance are coloured in accordance with the following code. GREEN-AND-YELLOW: BLUE: BROWN: EARTH NEUTRAL LIVE As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: the wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked with the letter E or by the earth symbol or coloured green or green-and-yellow. The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured red. WARNING -THIS APPLIANCE MUST BE EARTHED!If a 13-amp (BS 1363) fused-plug is used, it should be fitted with a 3-amp fuse. When fitting the connection to the gas inlet of the appliance , hold counterpart to avoid straining and possibly damaging. The gas bottle must only be used in an upright position and particular care must be taken every time the appliance is connected to the gas bottle to ensure that there are no leaks, that the gas pipe (rubber hose) is not under tension or kinked, and that it is not in contact with hot surfaces. The connection pipe and gas bottle should always be located in positions where they will not be tripped over or otherwise inadvertently disturbed. Before attempting to light the burner, every time after connection, turn on the gas at the bottle and check the gas connections for leaks by applying a soap and water solution over them and watching for bubbles, which would indicate a leak. After testing dry off traces of detergent. For your safety Do not check for leaks with a naked flame!Do not smoke while checking for leaks! 9. 1) The gas equipment consists of a multiple value (B) [value with built-in thermoelectric ignition control], the piezogas lighter (E), a burner with sparking plug and the gas-thermostat (F). Knob (B) can be turned to 2 function positions: : large flame = gas-flow open; : out position = gas supply to burner is closed. If, for any reason the gas flame extinguishes, the ignition control is working automatically and shuts off gas supply. 10. Open gas cylinder or pressure regulating valve. [. . . ] If necessary, a cloth dipped in warm water can be placed on the unit to help the defrosting process. After defrosting, mop up the defrosted water with a clean cloth and clean the cooler containers as described in chapter 4. Should the unit be out of operation for a prolonged period, turn off unit and remove contents. After defrosting, the cooler should be cleaned carefully and dried. [. . . ]