User manual AEG-ELECTROLUX RH060

[. . . ] Connecting to the mains The refrigerator must only be connected to the electricity supply using an earthed socket outlet, installed in accordance with local regulations. Before connecting the refrigerator, check from the data label inside the cabinet that the voltage agrees with your mains supply. Warning - This Appliance must be earthed. IMPORTANT SWITCHING ON Inside the refrigerator you will find a plastic bag contanining 4 small wheels. Carefully place the refrigerator on its back and insert the pins of the wheels into the metal holders located on the underside of the refrigerator. [. . . ] In this way food remains moist, odours do not form and neither does excess ice form on the cooling unit. Allow hot food and drink to cool down before placing them in the refrigerator. The temperature in the freezer section of the unit is set at - 12°C. Frozen products can be stored here for short periods (please follow the instructions on the packet very carefully!) NOTE: RH030 and RH060FDF1 do not contain freezer compartment Do not keep any easily combustible substances such as ether, petrol, adhesive, propane gas etc. in the refrigerator, it could explode! ICE CUBES Fill the ice-cube container to 4/5 with potable water. Place the ice-cube container in the freezer section. Wipe off any excess water to prevent the ice tray from freezing to the surface. To speed up the making of ice cubes, turn the thermostat to position 5 for a short while. Remember to turn the dial to its normal setting when the ice cubes are frozen. To remove the cubes from the ice tray, hold it under running water. The ice cubes can now be taken out easily. 4 CARE AND MAINTENANCE Defrosting Frost will gradually form on the cooling surfaces and it must not be allowed to become too thick since it impairs the cooling efficiency of the refrigerator. RH030 - RH060 Defrosting of the frost built up on the evaporator starts automatically for 2 hours long in every 24 hours. The defrost water is automatically evaporated by the heat generated by the appliance. After defrosting is completed, cooling will automatically be started again. Defrost water During the defrosting process the water runs through a hose into a container on the back of the refrigerator where it evaporates. This container does not need to be emptied. Cleaning Clean the inside of your refrigerator regularly to keep it fresh and gygienic. Switch off the appliance and pull out the plug. Clean the interior and fittings carefully with a mild detergent in lukewarm water. Never use acidic, abrasive or strongsmelling detergents or wax polishes as these will damage the surfaces and leave an unpleasant smell. The wooden housing should be dusted from time/to/time or wiped down with a damp cloth. The door seal should onlz be cleaned with water and rubbed down with talcum powder from time to time. [. . . ] If after checking all the above points, the refrigerator is still not working satisfactorily, contact your nearest service engineer. This refrigerator is equipped with overheating protection. An authorised service technician can check whether this has been triggered or not. State the problem, model and product number. [. . . ]