User manual AEG-ELECTROLUX RH200

[. . . ] It is dangerous to alter the specifications or modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible content loss. [. . . ] There should be 20mm clearance to the wall Figure 2. 5 3. Ventilation must be provided as shown in alternatives A, B, C or D (fig 2-3) 4. The ventilation duct must at least measure 105mm x the width of the refrigerator 5. Only the entire cooling unit must project into the duct as shown 6. Air passing through the duct must not be preheated by any source of heat 7. Ventilation grills, if used, must have openings of at least 200cm2 each During installation, please ensure the mains plug is accessible at all times. 5. Using the appliance To start the refrigerator connect the plug to the socket outlet and switch on the socket. The cooling fins should show signs of cooling after about 3 hours. The refrigerator needs about 6 hours at normal ambient temperature to reach 6 °C in the storage compartment. Figure 3. 5. 1. Temperature regulation The usual setting required is in the region of 2 to 3 on the thermostat knob (Fig. 4), but this can vary with conditions of load and installation. If it is found necessary to alter the setting, the knob can be turned to a higher number to produce a colder temperature, or a lower number to produce a warmer temperature. The effect of any adjustment can be checked by means of the thermometer after leaving the refrigerator operating for a further period to settle down again. Figure 4. 6 6. ICE CUBES Fill the ice tray to 4/5 with drinking water, cover with the lid and place the closed ice tray on the ice-tray shelf. Wipe off any excess water to prevent the ice tray from freezing to the surface. To speed up the making of ice cubes, turn the thermostat to position 5 for a short while. Remember to turn the dial to its normal setting when the ice cubes are frozen. To remove the cubes from the ice tray, hold it under running water. Remove the lid with the ice cubes from the ice tray and the ice cubes can now be taken out easily. 7. Useful suggestion Do not overfill the appliance. It is advisable to leave some space between the products in the cabinet to ensure efficient and even cooling. If the shelves are packed too tightly there may be unacceptable temperature variations. Frost will gradually form on the cooling surfaces and it must not be allowed to become too thick since it acts as an insulator and interferes with the cooling. [. . . ] An authorised service technician can check whether this has been triggered or not. In the event of a fault developing, contact your nearest Service Centre-see local telephone directory. Figure 11 15. Putting into operation Technical data: Model Type Gross volume Mains operation Input Energy consumption Climate class Refrigerant EA 3100 MF20-60 31 litre 100V (AC) 90W 0. 97 kWh/24h N 245g NH3 + H2O EA 3080 RA 80; RH 200 MF20-60 23 litre 100V (AC) 90W 0, 92 kWh/24h N 245g NH3 + H2O EA 3140 RA 140 MF20-60 41 litre 100V (AC) 90W 1. 07 kWh/24h N 245g NH3 + H2O 9 15. 1 Connecting to electrical mains The appliance may only be operated from nominal voltage mains as shown on the data plate. The appliance mains plug may be connected to a mains socket earthed in accordance with regulations. [. . . ]