User manual AEG-ELECTROLUX RH237LD

[. . . ] Parts which heat up should not be exposed. Wherever possible the back of the product should be close to a wall but leaving the required distance for ventilation as stated in the installation instructions. Before defrosting, cleaning or maintenance work is carried out, be sure to switch off the appliance and unplug it. DO NOT USE SHARP INSTRUMENTS to scrape off frost or ice. [. . . ] The more ventilated the condenser is, the more effective the refrigeration will be. The other condition for satisfactory operation is that the appliance stands on a flat surface. This is best seen by placing a glass of water on top of the appliance. It is important that the appliance is not directly exposed to radiated heat (sunlight, radiator, near an oven, etc. ). 4. 1. Installation instructions The refrigerator is equipped with an electrically heated absorption cooling unit which is virtually silent in operation. The fridge is designed for free-standing installation, but can be built-in if the following conditions are complied with to ensure satisfactory operation and maximum cooling efficiency. IMPORTANT Please follow the installation details below carefully Guarantee is valid for products installed as described only. The refrigerator must be level both directions 2. There should be 20mm clearance to the wall Figure 2. 5 3. Ventilation must be provided as shown in alternatives A, B, C or D (fig 2-3) 4. The ventilation duct must at least measure 105mm x the width of the refrigerator 5. If we want to switch off the unit, turn the thermostat knob to "0", disconnect the refrigerator from the electricity supply and leave the cabinet door open. After defrosting the cabinet interior should be wiped out with a clean, damp cloth. If the lightbulb needs changing, pull out the plug and proceed as follows: Press the metal reflector to one side and draw the lamp covering backwards. Replace the bulb and push the covering back into place. A new 10-watt bulb can be obtained at any service shop. 8. Defrosting, cleaning and maintenance Figure 5. 9. Changing the lightbulb (If available) 10. Remove the door, together with the two hinges (2), from the housing. Remove the two cover caps (3) from the housing and place them in the open hinge holes in the housing. Place the bottom righthand hinge in the top left of the door and the top righthand hinge in the bottom left of the door and hang the door on its hinges in the open Figure 6. 7 cover cap holes in the housing. Secure the hinges and cover caps with the 8 screws. [. . . ] In the event of a fault developing, contact your nearest Service Centre-see local telephone directory. Figure 11 15. Putting into operation Technical data: Model Type Gross volume Mains operation Input Energy consumption Climate class Refrigerant EA 3100 MF20-60 31 litre 100V (AC) 90W 0. 97 kWh/24h N 245g NH3 + H2O EA 3080 RA 80; RH 200 MF20-60 23 litre 100V (AC) 90W 0, 92 kWh/24h N 245g NH3 + H2O EA 3140 RA 140 MF20-60 41 litre 100V (AC) 90W 1. 07 kWh/24h N 245g NH3 + H2O 9 15. 1 Connecting to electrical mains The appliance may only be operated from nominal voltage mains as shown on the data plate. The appliance mains plug may be connected to a mains socket earthed in accordance with regulations. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ]