User manual AEG-ELECTROLUX RH361D

[. . . ] This is a natural compound also used in household cleaning agents (1 litre of Salmiak cleaner contains up to 200g of ammonia - about twice as much as is used in the refrigerator). Sodium chromate is used for corrosion protection (less than 2% of the coolant). If a leak occurs (which can be easily detected due to the unpleasant smell): Switch the device off (pull mains plug, if applicable); Ventilate room thoroughly. For the safety of hotel guests and personnel, it has been established by inspectors that the coolant poses no threat to health. 3. 0 WARRANTY AND CUSTOMER SERVICE Warranty arrangements are in accordance with EC Directive 44/1999/CE and the normal conditions applicable for the country concerned. [. . . ] Use a soft cloth, lukewarm water and a mild detergent. Following this, wash out the miniBar using clean water and dry thoroughly. At annual intervals, remove dust from fridge aggregate using a brush or soft cloth. ATTENTION To prevent material damage: Do not use soap or detergents which are harsh, coarse or which contain soda. Keep the door seal free from oil and grease. The cylinder locks have been lubricated in the factory to be long-lasting. 4 4. 5 Installation 200 cm² 20 mm IMPORTANT: Please follow the installation details below carefully. Guarantee is valid for products installed as described only. 1. The refrigerator must be level both directions 2. There sould be 20mm clearance to the wall 3. Ventilation must be provided as shown in alternatives A, B, C or D 4. The ventilation duct must at least measure 105mm x the wtdth of the refrigerator 5. Only the entire cooling unit must project into the duct as shown 6 Air passing through the duct must not be preheated by any source of heat 7. Using a red dot in the display window (A, point 3), the ADC shows that the miniBar´s door has been opened. Open the miniBar, check its contents and - if applicable- stock it up again. Insert ADC key and turn to the right. All other models 2. Insert ADC key and turn to the left. The red dot has disappeared now. Remove ADC key. 5. 5. 1 Automatic Door Control (electrical) When the miniBar is opened, a magnetically operated approximation switch located underneath on the fridge is activated (FIG 1. ) Depending on the connection (opening/closing mechanism), an electric circuit is closed or opened. Accordingly, this is registered and processed at the hotel reception. The miniBar´s wiring connection is situated at the rear of the appliance and consists of a 3-pin terminal strip (1). 1= terminal strip 2= approximation switch A= blue (opening mechanism) B= black (closing mechanism) C= white FIG. 1 11 5. 6. 1 5. 6 Interior Light RH456LD /E Model RH456LD/E is fitted with low voltage lighting. When the door is opened, the light in the cooling shelf is switched on via a sensor. The light in the uncooled storage shelf is switched on manually by means of a switch integrated into the lamp. 5. Clip reflector disk back in. 5. 6. 2 Interior Light (All other models) When the door is opened, the light in the cooling shelf is switched on via a sensor. Changing the LED-board: 1. [. . . ] d. ) Defective electronics or sensor feelers. f. ) The device is in its defrosting phase. f. ) See operating instruction 5. 3 Self Help a. ) Set temperature control to middle position. Authorised Service Failure : No cooling (the aggregate is warm). [. . . ]