User manual AEG-ELECTROLUX RKE300

[. . . ] The operating instructions include information on how you can help protect the environment. Contents Before using your machine for the first time Language selection Safety instructions Safety Transport/Winter storage Packing material Recycling Child safety General Child safety catch Activating/deactivating Child-safe start Description of the tumble dryer Advice and tips before you tumble-dry Materials that can be tumble-dried Materials that must not be tumble-dried Static electricity Tumble drying Sort your fabrics Select the programme Press the Start button Drying programme finished Settings You can carry out the following settings How to choose the settings: Audible Volume Language Child-safe 3 3 4 4 4 4 5 6 6 6 6 7 8 8 8 8 9 9 10 12 13 14 14 14 14 14 14 Care and cleaning Cleaning the lint filter Emptying the condensed water container Cleaning the steamer filter Cleaning the outside of the machine Troubleshooting The machine will not start Overheating cut-out Drying takes too long Error messages Technical information Technical data Standard tests Service Before contacting the service division Installation Positioning the tumble dryer Adjusting the feet Condensed water Electrical installation Door hanging Follow these instructions: Quick guide 15 15 15 16 16 18 18 18 18 18 19 19 19 20 20 21 21 22 23 23 24 25 28 2 Before using your machine for the first time Language selection You will be prompted to select the display language when you have connected your machine and start it for the first time. Do as follows: Turn the programme selector to choose from: US English, English, Svenska, Dansk, Norsk, Suomi, Français, Deutsch, Italiano, Espanol, Русский, Nederlands. Press Stop to save the setting. Laundry labels Certain materials are not suitable for tumble-drying. Always check and follow the instructions on each item’s laundry label. [. . . ] The table shows the effect of using different spin speeds when washing the load. Consumption can vary depending on room temperature, humidity, load, variations in the power supply and selected options. For the consumption values given below, the requirements are as follows: Temperature of intake air: Moisture content of intake air: Drying temperature: 23 °C 55 % Normal Program Auto extra dry Material Cotton, linen Load Spin speed (rpm) Energy consumption, approx. (min) (kWh) 1/1 800 rpm 1000 rpm 1400 rpm 1600 rpm 2, 4 2, 0 1, 9 1, 8 2, 0 1, 8 1, 6 1, 5 1, 0 1, 8 1) 3:15 2:50 2:40 2:35 2:50 2:30 2:15 2:05 1:25 2:30 2:20 2:00 1:40 0:55 2:10 1:55 1:30 1:10 Auto dry Cotton, linen 1/1 800 rpm 1000 rpm 1400 rpm 1600 rpm Crease-resistant, polyester/cotton Auto normal dry Cotton, linen 1/2 1/1 1000 rpm 800 rpm 1000 rpm 1400 rpm 1600 rpm 1, 68 1, 4 1, 2 0, 65 1, 6 Crease-resistant, polyester/cotton Auto Iron dry Cotton, linen 1/2 1/1 1000 rpm 800 rpm 1000 rpm 1400 rpm 1600 rpm 1) 1) 1, 39 1, 1 0, 8 1) Test programme in accordance with EN61121:2005. During testing, the tumble dryer must be set to 10A and Time saver must be activated. After washing, the load must be spun at 1000 rpm. 11 Tumble drying 5 Press the Start button Remaining drying time An estimate of the remaining drying time will be shown on the display a few minutes after the drying programme starts. For example, "1:35" means that it will take approximately 1 hour and 35 minutes for the load to dry. The actual remaining time may be longer than the estimated time shown on the display. The remaining time is then shown as "0:15" until the load is sufficiently dry. You can stop the tumble dryer by pressing the Stop button or by opening the door. In both cases the programme is stopped and starts from the beginning if restarted. The programme will not be affected if you change the programme selector after the programme has started. 12 Tumble drying 6 Drying programme finished The compressor's cooling fan continues to run after the programme finishes, but stops automatically or when any button/knob is activated. Use a soft, dry cloth to remove any deposits. Remove the foam filter found behind the net filter. Clean the outside of the machine and the programme panel with a mild cleaner. Do not use solvents, as these can damage the machine. Do not hose down or spray the machine with water. Do not allow dust to accumulate around the machine. Keep the area around the tumble dryer 16 Care and cleaning clean and cool; dust, heat and moisture prolong drying times. 17 Troubleshooting The machine will not start Check • that the door is properly closed. • that the main power switch is on. • that the Delayed Start option has not been selected. To cancel Delayed Start, press the Stop button for three seconds. • that the main fuses have not blown. [. . . ] Option 2 allows you to remove the small short hose from the nipple. Attach the rubber hose supplied to the same nipple. The water can then be pumped out into a sink or a floor drain (2a). 2 1 Max 1000 mm 2a Electrical installation If the machine is delivered from the factory with a plug attached it can be connected to an earthed wall socket. Otherwise, a permanent connection using a multipolar circuit breaker must be made by a qualified professional. Connection on delivery • 230V, 1-Phase, 10A • 50Hz • Use a type A residual-current device. Coin operation The machine is prepared for coin operation. [. . . ]