User manual AEG-ELECTROLUX RM2250

[. . . ] The appliance, which works silently, meets high quality standards and guarantees the efficient utilisation of resources and energy throughout its entire life cycle, during manufacture, in use and when being disposed of. Before you start to use the appliance, please read the installation and operating instructions carefully. The refrigerator is designed for installation in leisure vehicles such as caravans or motorcaravans. The appliance has been certified for this application in accordance with EU Gas Directive 90/396/EEC. 2. 0 2. 1 FOR YOUR SAFETY Danger Attention Warning and safety notices Never use a naked flame to check the appliance for leaks. [. . . ] When the ambient temperature falls below +8C, the optional winter covers should be fitted. This protects the unit from excessively cold air. 3. It is also recommended that the winter covers should be used when the vehicle is taken out of TIP service for an extended period of time. 5. 9 Interior light (when fitted) Changing the light bulbs 1. Fit new light bulb. Note: for 12V DC : 1 light bulb 8V, 2W for 24V DC : 2 light bulbs 28V, 1, 5W 4. Clip the cover back in place. Please contact Dometic Service centres for replacement light bulbs. 10 5. 10 Changing the decor panel If changing of the decor panel is required, turn to your dealer, please. 5. 11 Positioning the storage rack Dismantling: 2. 1. 1. Loosen the front and back securing brackets. Move the storage rack to the left and remove it. To fit the storage rack, the reverse order applies. 11 5. 12 Troubleshooting Before calling the authorised Service department, please check whether: 1. The instructions in the section "Using the refrigerator" have been followed. The refrigerator is not tilted excessiveley. It is possible to operate the refrigerator with an available power source. Failure 1: The refrigerator does not work in gas operation mode. Action you can take a. ) Change gas bottle. Excessive heat impairs performance and raises the energy consumption of the refrigerator. Any installation that is not carried out by qualified persons will jeopardize the manufacturer's guarantee. 6. 1. 1 Side Installation If the appliance is installed on the same side of the vehicle as the entrance door, it is desirable that the door does not cover the refrigerators vents. If this cannot be avoided there must be a gap of at least 25mm between the door and the vents. 6. 1. 2 Rear installation If the refrigerator is mounted at the rear of the vehicle you must ensure the lower grille is not covered by the bumper or rear lights. This would be prevent the air from circulating properly and cause problems in warm weather. Air vent grille not blocked: OK!Fig. 2 15 6. 2 Draught-free installation Proposal 1: The refrigerator must be sealed in accordance with EN 1949. Illustrated below are two typical approved methods of sealing. Using the Installation Sealing Kit from Dometic (SP. No. 241 2559-00, available from Dometic) Insert lipped seals (A) into the installation recesses at the bottom and at each side. Insert deflector plate (B), fitted with a lipped seal (A) of heavy-duty, nonflammable material, into the installation recess (see Fig. Insert deflector plate (B) in such a way that the hot air escapes through the air vent grating into the open air. Affix the discharge plate to the caravan wall, not to the refrigerator!In addition, discharge plate (B) with its lipped seal (A) must seal the refrigerator off from the living area (see Fig. [. . . ] The gas connection (1) to the appliance must be installed securely and at zero potential using tube connectors and must be securely connected to the vehicle (a hose connection is not permissible). Inflamable material should not be in immediate proximity to the burner. 21 The gas connection to the appliance is effected by means of a suitable coupling tube fitting L8, DIN 2353-ST, complying with EN 1949. Ermeto) The gas connection may only be carried out by a qualified personnel. SW 17 SW 14 Following proper installation, a testing for leakage and a flame test must be carried out by *qualified personnel in compliance with Worksheet G607 or EN1949 respectively. [. . . ]