User manual AEG-ELECTROLUX RM3250

[. . . ] The appliance, which works silently, meets high quality standards and guarantees the efficient utilisation of resources and energy throughout its entire life cycle, during manufacture, in use and when being disposed of. Before you start to use the appliance, please read the installation and operating instructions carefully. The refrigerator is designed for installation in motorcaravans. The appliance has been certified for this application in accordance with EU Gas Directive 90/396/EEC. 2. 0 2. 1 FOR YOUR SAFETY Danger Attention Warning and safety notices Never use a naked flame to check the appliance for leaks. [. . . ] Place the ice cube tray in the freezer compartment. Only use drinking water! 5. 7 Door locking Park-position: 10 5. 8 Winter operation 1. Check that the ventilation grilles and the extractor have not been blocked by snow, leaves or similar. Lower ventialtion grille Upper ventilation grille with flue vent 2. When the ambient temperature falls below 8°C, the optional winter covers should be fitted. This protects the unit from excessively cold air. 3. It is also recommended that the winter cover should be used when the vehicle is taken out of service for an extended period of time. 5. 9 Interior light (when fitted) Changing the light bulbs 1. Fit new light bulb. Note: For 12V DC : 1 light bulb 12V, 1, 5W 4. Clip the cover back in place. Please contact Dometic Service centres for replacement light bulbs. 11 5. 10 Changing the decor panel 1. Open the door and loosen the hinge screw. 2. Take off the door by moving it upwards. 3. Remove the decor plate and insert a new decor plate. 5. Screw the door strip back in position. 6. Installation and connection of the appliance must comply with the latest technical regulations, as follows: The electrical installation must comply with national regulations ( EN 60335-1 for Europe). The gas installation must comply with national regulations. Technical regulations, liquid gas (TRF 1996) Technical regulations, DVGW Worksheet G 607 (DIN EN 1949) Technical regulations, EN 732 Local and building control department requirements The appliance shall be installed in such a way that it is shielded from excessive heat radiation. Excessive heat impairs performance and raises the energy consumption of the refrigerator. Any installation that is not carried out by qualified persons will jeopardize the manufacturer's guarantee. 6. 1. 1 Side Installation If the appliance is installed on the same side of the vehicle as the entrance door, it is desirable that the door does not cover the refrigerators vents. If this cannot be avoided there must be a gap of at least 25mm between the door and the vents. 6. 1. 2 Rear installation If the refrigerator is mounted at the rear of the vehicle you must ensure the lower grille is not covered by the bumper or rear lights. This would be prevent the air from circulating properly and cause problems in warm weather. Air vent grille not blocked: OK!Fig. 2 18 6. 2 Draught-free installation Proposal 1: Your refrigerator must be sealed in accordance with EN 1949. Illustrated below are two typical approved methods of sealing. Insert lipped seals (A) into the installation recesses at the bottom and at each side. Insert deflector plate (B), fitted with a lipped seal (A) of heavy-duty, non- flammable material, into the installation recess (see Fig. Insert deflector plate (B) in such a way that the hot air escapes through the air vent grille into the open air. [. . . ] A fixed, pre-set pressure regulator complying with EN 12864 must be connected to the liquid gas cylinder. The pressure regulator must concur with the operating pressure specified on the data plate of the appliance. The operating pressure corresponds to the standard pressure of the country of specification (EN 1949, EN 732). Only one connection pressure is permissible for any one vehicle. [. . . ]