User manual AEG-ELECTROLUX RM4262S

[. . . ] This refrigerator comes with an Automatic Energy Selector (AES) which controls operation and energy supply. To put the refrigerator in operation, just trip the main switch - AES manages the rest. CONTENTS OPERATING INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 CONTROLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 STARTING THE REFRIGERATOR . . . . . . . . . . . . . . [. . . ] Never put bottles or cans of fizzy drinks in the frozen food storage compartment as they may burst when freezing. Most kinds of frozen food can be stored in the frozen food compartment for about a month. This period of time may vary, however, and it is important to follow the instructions on the individual packages. HEATING CABLE During the summer months of high temperatures and humidity, the metal frame between the freezer and fresh food compartments may have water droplets forming. This refrigerator comes standard with a 12 V (DC) heating cable that will evaporate the water droplets when they form. To have the heating cable on, you position the switch located beneath the control panel to I. The heating cable can be left on continuously or only used when temperatures require it. Note: The heating cable will draw 12 V (DC) power continuously when in the ON (I) position. It should be turned OFF (0) when a charging source is not available. ICE MAKING Fill the ice tray to just below the brim with drinking water and place it on the freezer shelf. Ice will be made more rapidly if the thermostat is set at its highest position, but be sure to move the thermostat back to normal setting when the ice is formed, the refrigerator might otherwise become too cold. DEFROSTING Frost will gradually accumulate on the refrigerating surfaces. It must not be allowed to grow too thick as it acts as an insulator and adversely affects refrigerator performance. Check the formation of frost regularly every week and when it gets about 3 mm thick, defrost the refrigerator. if the refrigerator does not operate in DC mode when the engine is running: Is the alternator (D+) connection made correctly?if the AES LED (C) flashes red: see chapter Gas trouble-shooting. SOME USEFUL HINTS Make sure that: · · · · · Defrosting is carried out periodically The refrigerator is clean and dry with the door left open when it is not to be used for some time. Liquids or items with a strong odour are well packed. The ventilation openings are unobstructed. The doors are secured by means of the both travel catches when the caravan is on the move. 3. 4. SERVICE AND SPARE PARTS Service and spare parts are obtainable from your dealer or Electrolux - consult the telephone directory. INSTALLATION INSTRUCTIONS REPOSITIONING THE HINGES The refrigerator is equipped with reversible doors. A special door reversing kit must be used to reverse the doors. For further information, contact your dealer or Electrolux. 5. 6. If the refrigerator is not cold enough it may be because: 1. The ventilation is inadequate owing to reduced area of the ventilation passages (partial blockage of grilles from wire mesh etc. ). The temperature control setting is incorrect. The gas pressure is incorrect - check the pressure regulator at the gas container. [. . . ] 12 V supply must not be connected to a voltage controller or similar device as the AES itself monitors the DC voltage. +12 V should be permanent attached, and must not be cut out when the ignition key is turned off. All connections should be screwed or soldered to keep voltage drop to a minimum. The positive conductor must be protected by a 20 A fuse. [. . . ]