User manual AEG-ELECTROLUX RM4280

[. . . ] The refrigerator is designed for building-in to leisure vehicles such as caravans or motorhomes. The appliance is certified according to the EU-Gas-Directive 90/396/EEC. CONTENTS OPERATING INSTRUCTIONS TRANSIT DAMAGE Inspect the refrigerator for damage. Transit damage must be reported to whoever is responsible for delivery not later than seven days after the refrigerator was delivered. DATA PLATE Check the data plate, inside the refrigerator, to ensure that you have received the right model. the following details: Model designation Product number Serial number Since these details will be needed if you have to contact service personnel, it is a good idea to make a note of them here. CONTROLS STARTING THE REFRIGERATOR WINTER OPERATION REGULATING THE TEMPERATURE TRAVEL CATCH FOOD STORAGE ICE-MAKING DEFROSTING CLEANING THE REFRIGERATOR TURNING OFF THE REFRIGERATOR IF THE `FRIDGE FAILS TO WORK MAINTENANCE SOME USEFUL HINTS GUARANTEE AND SERVICE TECHNICAL DATA 10 8 8 8 8 9 9 9 9 9 9 9 10 10 10 8 INSTALLATION INSTRUCTIONS REPOSITIONING THE HINGES DOOR PANEL BUILDING-IN VENTILATION OF THE UNIT LP GAS CONNECTION ELECTRICAL CONNECTION 10 10 10 11 11 11 12 OPERATING INSTRUCTIONS CONTROLS The refrigerator can be run on either 230 V, 12 V or LP gas. [. . . ] Also don't give children ice lollies straight from the frozen food as they could cause frost burns. Most kinds of frozen food can be stored in the frozen food compartment for about a month. This period of time may vary, however, and it is important to follow the instructions on the individual packets. TURNING OFF THE REFRIGERATOR If the refrigerator is not to be used for some time: 1. Shut off any on-board valve in the gas line to the refrigerator. Defrost and clean it as described earlier. Leave the doors of the refrigerator and the frozen food compartment ajar. Use the travel catch to hold in this position. When the vehicle is laid up for a long period of time (e. g. during the winter months), we suggest fitting the winter covers WA120, fig. 2, onto the vent grills. ICE MAKING It is practical to make ice during the night - then the refrigerator is less demanded and the cooling unit has more reserves. Fill the ice tray to just below the brim with drinking water and place it on the freezer shelf. The door is not properly closed or the magnetic sealing strip is defective. More than one source of energy is used at the same time. If the refrigerator still does not work properly, call a service technician. The sealed cooling system must not be opened, since it is under high pressure. TECHNICAL DATA Overall dimensions, refrigerator Height Width Depth (incl. cooling unit) without door with door Build-in dimensions Height Width Depth Capacity gross net frozen food compt Weight (without packaging) Electrical data Input 230 V 12 V Energy consumption /24 h LP gas data Input ditto, low flame Energy consumption /24 h Cooling medium Ammonia (R 717) RM 42XX 618 mm 486 mm 435 mm 474 mm 620 mm 490 mm 450 mm 60 51 6 21 lit. kg MAINTENANCE Concerning gas- and electric installations, only authorized experts are allowed to carry out maintenance and repair works. Besides, it is recommendable to contact an authorized service if it comes to repair works. According to the valid regulations G607 of DVGW, the gas installation as well as the connect flue oulets are to be checked every two years by an expert (this has to be arranged by the person responsible). 105 watt 100 watt 2, 3 kWh 186 watt 86 watt 0, 24 kg SOME USEFUL HINTS Make sure that: The refrigerator is not operating on 12 V when the vehicle is parked, otherwise you will drain the car battery in a short time. The refrigerator is left with the door(s) ajar when it is not to be used for some time. Liquids or items with a strong odour are well packaged. The ventilation openings are unobstructed. [. . . ] If any other material is used, it must be of a type approved for use with continuously operating bottled- gas appliances, and have threaded compression connections throughout. PUSH-ON CONNECTIONS MUST NOT BE USED (We do not approve the use of "rubber" type flexible tubing for connecting permanently operating appliances of this type in the United Kingdom). should be of a type specifically designed for the type and diameter of the connection pipe used, and screwed joints should be sealed with a joining compound approved for use with bottled gas. The gas supply pipe should be connected to the gas inlet pipe on the right hand side of the gas control valve by means of a suitable threaded compression coupling. [. . . ]