User manual AEG-ELECTROLUX RM4285LM

[. . . ] MANUAL CARAVAN AES II RM 4185 RM 4215 RM 4235 RM 4265 RM 4275 RM 4285 Deutsch English Français Italiano Español Seite page page pagina pagina 1 7 14 20 26 Svenska Dansk Norsk Nederlands Suomi RM 4365 RM 4405 RM 5215 RM 5275 RM 5405 sida side side pag. sivu 32 38 44 50 57 C 40/ 110 821 2647. 12 T. B. 8 '97 OPERATING AND INSTALLATION INSTRUCTIONS FOR ELECTROLUX REFRIGERATORS INTRODUCTION We are pleased that you have chosen this refrigerator and hope you will derive much satisfaction from using it, but first a few well-meant words of advice: It is important to read through these instructions carefully before using the refrigerator. To ensure good refrigeration and economical operation, the refrigerator must be installed and used as described in these instructions. [. . . ] Fill the ice tray to just below the brim with drinking water and place it on the freezer shelf. To speed up the ice making, one can spill one or two spoonfuls of water on the freezer shelf to improve the contact to the ice tray. If you have more than one ice tray it is a good idea to make ice in advance and save the frozen trays in the frozen food compartment. IF THE `FRIDGE FAILS TO WORK Check the following points before calling a service technician: 1. that the green AES LED goes on, when the switch (A) is set to "ON" (12 V must be available). when mains are connected but the fridge stays in gas oeration: Is the refrigerator correctly connected and is the fuse intact?in transit, if the fridge does not operate in DC mode: Is the alternator (D+) connection made correctly ?if the AES LED flashes red: see chapter Gas TroubleShooting. If the refrigerator is not cold enough it may be because: 1. The ventilation is inadequate owing to reduced area of the ventilation passages (partial blockage of grilles from wire mesh etc). The temperature control setting is incorrect. The gas pressure is incorrect ­ check the pressure regulator at the gas container. 9 DEFROSTING Frost will gradually accumulate on the refrigerating surfaces. It must not be allowed to grow too thick as it acts as an insulator and adversely affects refrigerator performance. Check the formation of frost regularly every week and when it gets about 3 mm thick, defrost the refrigerator. To defrost the `fridge, turn it off and remove the ice tray and all food items. It must be sturdy enough to carry the weight of the `fridge. Battens should be installed at the enclosure and fitted with sealing strips, as shown in fig. (Other suggestions for a sealed installation are shown in a folder which can be obtained from Electrolux). Slide in the refrigerator until it is flush with the front of the recess. There must be 10-20 mm free space behind the refrigerator. Four fasteners are fitted in plastic bushings in the side walls of the fridge, fig. They are used for securing the refrigerator in the enclosure. [. . . ] The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured red. LP GAS CONNECTION The refrigerator is designed for operation on LP gas, the pressure of which must be 28 mbar for Butane and 37 mbar for Propane. Check that this is stated on the data plate. The refrigerator is not designed for operation on town gas or natural gas. 11 WARNING!In the United Kingdom, the plug or circuit to the refrigerator must be fitted with a fuse not greater than 5 amps. [. . . ]