User manual AEG-ELECTROLUX ROTOSOFT3000B

[. . . ] and please pass it to any future owner of the appliance. We wish you much joy with your new appliance. OPERATING INSTRUCTIONS IMPORTANT SAFETY INFORMATION ENVIRONMENT INSTALLATION Transporting the appliance Appliance positioning Removing transport safety packaging Electrical connection Changing door stop Special accessories PRODUCT DESCRIPTION CONTROL PANEL Control panel Display BEFORE FIRST USE PROGRAMME CHART DAILY USE Sorting laundry Average laundry weights Switching appliance/drum light on Laundry loading Selecting the programme 29 29 31 32 32 32 32 33 33 34 35 36 36 36 37 37 39 39 39 40 40 41 41 INTENSIVE (TROCKNEN PLUS) function 41 LONG ANTI-CREASE (KNITTERSCHUTZ PLUS) function 41 BUZZER (SIGNAL) function 42 TIME (ZEITWAHL) function 42 DELAY START (ZEITVORWAHL) 42 CHILD LOCK function 42 Starting the programme 43 Changing programme 43 Laundry unloading 43 CARE AND CLEANING 44 Cleaning fluff filter 44 Cleaning the door seal 45 Emptying the water reservoir 45 Cleaning heat exchanger filters 46 To clean the drum 48 Clean operating screen and housing 48 WHAT TO DO IF . 49 MACHINE SETTINGS 50 TECHNICAL SPECIFICATIONS 51 SERVICE 52 Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. [. . . ] Unscrew door lock E, push down slightly D and remove from the front of the appliance. Push snap-in button F in and down, push cover down slightly and remove from front of the appliance. Change door lock E over to the opposite side, screw down the door interlock. On the other side, insert cover F and allow snap-in button to lock into place. Insert loading door and hinges into recesses on the front of the appliance and screw down. Note regarding contact protection: The appliance is only secure for operations again once all plastic parts have been inserted. Read carefully the instructions supplied with the kit. DRAINING KIT Available from your authorized dealer (can be attached to some types of the tumble dryers). Installation kit for through draining of the condensed water into a basin, siphon, gully, etc. Installed hose must be on the height from minimum of 50 cm to maximum of 1 m from floor level. Read carefully the instructions supplied with the kit. Push the DELAY START (ZEITVORWAHL) button again and again until the necessary deif the programme has to start after 12 lay start is shown in the display, e. The child lock can be set to prevent a programme being accidentally started or a programme in operation being accidentally changed. the child lock function locks all buttons and the programme knob. The child lock can be activated or deactivated by holding down the LONG ANTI-CREASE (KNITTERSCHUTZ PLUS) (3) and BUZZER (SIGNAL) (4) buttons simultaneously for 5 seconds. ­ Before programme is started: Appliance cannot be used ­ After programme is started: Programme in operation cannot be changed The icon appears in the display to indicate that the child safety device is activated. The child safety device is not deactivated once the programme comes to an end. If you want to set a new programme, you must first deactivate the child safety device. When program is started only current cycle phase is indicated by single icon. To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF (AUS) and then reset the programme. The programme cannot longer be changed directly once the programme has started. The drying programme is not however affected by this (laundry protection). [. . . ] Loading door does not close Filters not locked in place. E51- only dryers with the LCD): Switch the dryer off and on. 5) only dryers with the LCD 6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section). Only use a special bulb which is designed specially for dryers. [. . . ]