User manual AEG-ELECTROLUX S 64

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/or with signal words (Warning!This symbol guides you step by step in the operation of the appliance. [. . . ] The cut surfaces of the worktop (C) should be varnished to avoid swelling due to penetration of moisture. The appliance wall distance must beat least 30 mm and should be checked before the ventilation grille is inserted. After the worktop has been removed the appliance can be installed underneath a continuous worktop. Lift the worktop slightly, push it about 20 mm towards the rear, and lift it off upwards (2). To remove the top of the refrigerator unfasten the screws on the front-right- and front-left-hand side (3) and keep it in a safe place (4). Level the appliance by adjusting the two adjustable feet (1) at the front of the appliance. The side at which the door opens can be changed from the right side (as supplied) to the left side, if the installation site requires. When changing the side at which the door opens, the appliance must not be connected to the mains. Carefully tilt the appliance to the back and place an adequate object under it. take care to avoid the compressor or the condenser touching the ground. Unscrew the adjustable feet situated on both sides (2 pieces), in addition the screws fixing the lower door holders (2 pieces) respectively the screw on the other side. Do not use soap or detergent as the smell may linger. Allow the appliance to stand for 2 hrs after installation. Leave the appliance for approximately 4 hours for the correct temperature to be reached before placing food inside. the thermostat control situated inside the refrigerator regulates the temperature of the larder compartment. Thermostat control is marked from 1-5 the higher the number, the colder the setting. To switch off the appliance, turn the temperature regulator to position"0". If the appliance is not going to be used for an extended period: 1. Switch off the appliance by turning the thermostat knob to position"0". Remove the mains plug or switch off or disconnect from the electricity supply. Leave the door open to avoid the build up of odours. Various glass storage shelves are included with your appliance. [. . . ] Do not leave the door open any longer than necessary. Temperature is set too The compressor runs concold. A large quantity of warm food was placed in the appliance within the last 24 hours. The appliance is near a Please look heat source. [. . . ]