User manual AEG-ELECTROLUX S1442-5ICH

[. . . ] Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/or with signal words (Warning!, Caution!, Attention!). Additional information regarding operation and practical applications of the appliance appear after this symbol. Tips and notes concerning economical and environmentally sound use of the appliance are marked with the cloverleaf. Printed on paper manufactured with environmentally sound processes. who thinks ecologically acts accordingly . . . 2 Contents Safety . [. . . ] Fill the ice cube tray 3/4 full with cold water, place it in the freezer compartment and leave to freeze. To loosen the frozen cubes, either bend the ice cube tray or hold it under running water for a few seconds. Never try to free an ice tray that is frozen to the freezer compartment using pointed or sharp edged objects. Use the ice scraper supplied. 10 Defrosting Refrigerator The refrigerator automatically defrosts every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. Freezer The freezer compartment, however, will become progrssively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However when the ice becomes very thick on the inner liner, complete defrosting should be carried out as follows: 1. Remove the frozen food from the freezer, wrap it in several layers of newspaper and put it in a very cool place. Switch off the appliance and pull out the plug. Fuse has blown or is defec- Check fuse, replace if tive. Mains malfunctions are to be corrected by an electrician. Appliance cools too much. Temperature is set too cold. Turn the temperature regulator to a warmer setting temporarily. . Temperature is not properly Please look in the "Initial adjusted. Door was open for an exten- Open the door only as long ded period. as necessary. The food is too warm. A large quantity of warm food Turn the temperature reguwas placed in the appliance lator to a colder setting temwithin the last 24 hours. The appliance is near a heat Please look in the "Installasource. tion location" section. Interior lighting does not work. Light bulb is defective. Please look in the "Changing the Light Bulb" section. Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. At the same time shape the warmed door seal by hand such that it sits correctly. Heavy build up of frost, pos- Door seal is not air tight sibly also on the door seal. (possibly after changing over the hinges). 14 Malfunction Unusual noises. Possible Cause Remedy Readjust the feet. [. . . ] For correct air circulation, it is important that the ventilation openings are not covered or obstructed. Important If the appliance is positioned under a kitchen wall unit, a minimum clearance of 10 cm must be left between the top of the appliance and the overhanging wall unit. 19 Rear spacers Fit the rear spacers contained in the documentation bag to ensure even dissipation of heat genereted during operation. Proceed in the sequence illustrated by the numbers in figures. 2 3 1 AEG68 AEG69 Levelling the appliance Place the appliance on a flat hard floor. Two adjustable feet on the front of the appliance enable it to accurately levelled by screwing them in or out as required. AEG70 Reversing the door The side at which the door opens can be changed from the right side (factory fitted) to the left side. [. . . ]