User manual AEG-ELECTROLUX S1678-1TK

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/ or with signal words (Warning!, Caution!, Important!). This symbol guides you step by step in the operation of the appliance. [. . . ] The procedure is as follows: Unscrew the Philips screws (F) on the F right and the left. G Lift the worktop slightly, push it about 20 mm towards the rear, and lift it off upwards (G). H Unscrew the holding bracket (H) and keep it in a safe place. G 56/1 Mounting under a continuous worktop If installed under a continuous worktop, the appliance is fastened with a mounting screw (A) under the panel. A AEG96 8 Reversing the door The side at which the door opens can be changed from the right side (as supplied) to the left side, if the installation site requires. When changing the side at which the door opens, the appliance must not be connected to the mains. Remove plug from the mains beforehand. Tilt the appliance slightly towards the rear and prop it securely. Unscrew the door hinge screws (K) and remove the hinge pin bracket (1). Open the door a little way and take it out downwards. K 1 AEG97 Unscrew the upper pin (A) and screw it into place on the opposite side. Fit the door into the upper pin (A) and close it. Screw the hinge pin bracket (1) securely into place on the opposite side using the screws (K). A 12 AEG98 Unscrew the handle. Refit it on the opposite side after having pushed in the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack. 9 Prior to Initial Start­Up Please clean the appliance interior and all accessories prior to initial start-up (see section: "Cleaning and Care"). Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. The water from the thawing frost evaporates by itself. Switching off the appliance To switch off the appliance, turn the temperature regulator to position "0". If the appliance is not going to be used for an extended period: Remove all refrigerated packages. Switch off the appliance by turning the temperature regulator to position "0". Remove the mains plug or switch off or disconnect the electricity supply. Clean thoroughly (see section: "Cleaning and Care"). Leave the door open to avoid the build up of odours. Cleaning and Care For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly. · The appliance may not be connected to the mains during cleaning. Before cleaning switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse. 14 · Never clean the appliance with a steam cleaner. Moisture could accumulate in electrical components, danger of electrical shock!Hot vapours can lead to the damage of plastic parts. [. . . ] To change the light bulb, undo the screw. Press the light bulb cover as shown and slide it towards the rear of the appliance. Refit the light bulb cover and the screw. Put the refrigerator back into operation. AEG65 18 Service & Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts, contact your local AEG Service Force Centre by telephoning: 08705 929 929 Your call will be automatically routed to the Service Centre covering your post code area. [. . . ]