User manual AEG-ELECTROLUX S170E

[. . . ] Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/or with signal words (Warning!, Caution!, Important!). This symbol and numbered instructions guide you step by step in the operation of the appliance. . . . . . 1 3 2 Supplementary information regarding operation and practical uses of the appliance appear after this symbol. Tips and notes concerning economical and environmentally sound use of the appliance are marked with the cloverleaf. [. . . ] · If there is a malfunction in the appliance that prevents the temperature from being further measured, all the lights on the temperature display flash. Prior to Initial Start­Up Before connecting the appliance to the mains and putting it into operation for the first time, leave the appliance to stand for 30 minutes if was transported upright. After transport on its side, the appliance must be left to stand for 4 hours before putting it into operation. This is necessary to allow the refrigerant to flow back into the compressor. Otherwise the compressor may be damaged. Please clean the appliance interior and all accessories prior to initial start-up (see section: "Maintenance and Cleaning"). 1 Initial Start-Up 0 1. Set the refrigerator to the desired temperature (see section: "Temperature Adjustment"). 3 Goods to be refrigerated can be loaded immediately after switching on, because the storage temperature in the refrigerator is quickly reached. 17 818 19 99-00/7 Temperature Adjustment With the , , +" and , , -" buttons the desired temperatures in the refrigerator can be adjusted. Press either the , , +" (WARMER) or , , -" (COLDER) button. The temperature display switches over and the DESIRED temperature currently set flashes on the temperature display. To adjust to a warmer temperature, press the , , +" (WARMER) button. To adjust to a colder temperature, press the , , -" (COLDER) button. A storage shelf must be inserted into the lower guide track above the salad bin. It must always remain in this position, so that fruits and vegetables remain fresh longer. The remaining storage shelves can be adjusted to various heights: 0 1. Pull the storage shelf forward until it can be tipped up or down and removed. To insert at a different height use the same procedure in reverse. Salad Bin The salad bin can be divided into sections by inserting the dividers. Insert the large divider in the middle or to the left side of the salad bin as required. 2. If the large divider is inserted in the middle of the bin the right hand side can be further divided by inserting the small divider in the middle or rear position. 3 The ventilation grille above the salad bin improves air circulation so that groceries keep for longer. 20 818 19 99-00/7 Interior Fittings Variable Inner Door The door compartments can be pulled up and removed, and inserted at other positions as needed. Bottle Holder Some models are equipped with a bottle holder in the bottle compartment. This is used to prevent individual bottles from falling over and can be slid sideways. 818 19 99-00/7 21 Proper Storage For physical reasons, the refrigerator compartment has different temperature zones. The coldest zone is on the lowest storage shelf immediately above the fruit and vegetable trays. Warmer zones are the upper storage shelves and door racks. The arrangement (see fig. ) indicates where different types of food are best stored to make the most of temperature variations. [. . . ] During this process, heat is released to the surrounding air at the surface of the condenser. The condenser is mounted on the base of the appliance. 28 818 19 99-00/7 Guarantee Conditions AEG offer the following guarantee to the first purchaser of this appliance. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation. The guarantee does not cover commercial use. [. . . ]