User manual AEG-ELECTROLUX S173-1IGB

[. . . ] Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/or with signal words (Warning!, Caution!, Attention!). Additional information regarding operation and practical applications of the appliance appear after this symbol. Tips and notes concerning economical and environmentally sound use of the appliance are marked with the cloverleaf. Printed on paper manufactured with environmentally sound processes. who thinks ecologically acts accordingly . . . 2 Contents Safety . [. . . ] Place the food to be frozen in the top drawer. Do not open the door frequently or leave it open longer than absolutely necessary. If large quantities of food are to be stored, remove all drawers according to type. Some appliance and place food on cooling shelves. Pay careful attention not to exceed load limit stated on the side of the upper section. 2. 4. Storage Goods Calendar Symbols/Freezing The symbols on the drawers show different types of frozen goods. The numbers indicate storage times in months for the appropriate types of frozen goods. Whether the upper or lower value of the indicated storage time is valid depends on the quality of the foods and pre-treating before freezing. The lower value applies to foods with high fat content. By attaching the included index-tabs to the drawers, they can be marked according to which type of foods the individual compartments contain. 10 Preparation of Ice Cubes 1. Fill the ice cube tray 3/4 full with cold water, place it in the freezer compartment and leave to freeze. Do not set temperature any colder than necessary. Put frozen food in the fridge to defrost. The cold in the frozen food will then be used to cool the fridge. Accumulation of dust at the condenser increases energy consumption. For this reason carefully clean the condenser at the back of the appliance once a year with a soft brush or a vacuum cleaner. Ensure the appliance is switched off. 13 Something Not Working If the appliance is not functioning correctly, please carry out the following checks before contacting your local AEG Service Force Centre. Warning! Repairs should only be carried out by qualified service engineers. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Malfunction Possible Cause Remedy Appliance is not switched on Switch on the appliance. Mains plug is not plugged in Insert mains plug. Fuse has blown or is defec- Check fuse, replace if tive. Mains malfunctions are to be corrected by an electrician. Appliance cools too much. Temperature is set too cold. [. . . ] Upon completion there must be not cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. A cut-off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut-off plug is disposed of safely. 2. 4. 18 Installation Location The appliance should be set up in a well ventilated, dry room. [. . . ]