User manual AEG-ELECTROLUX S1748TK

[. . . ] Intended use The refrigerator is intended for use in the home. It is suitable for the cooling, freezing and storing of frozen food, as well as for making ice. If the appliance is used for purposes other than those intended or used incorrectly, no liability can be accepted by the manufacturer for any damage that may be caused. Alterations or changes to the refrigerator are not permitted for reasons of safety. [. . . ] For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Pull off the adhesive tape on the left and right side of the door. The appliance should be set up in a well ventilated, dry room. energy use and efficient performance of the appliance is affected by the ambient temperature. The appliance should therefore - not be exposed to direct sunlight; - not be installed next to radiators, cookers or other sources of heat; - only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed. The climate classification can be found on the serial plate, which is located at the left on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification: Climate classification SN N ST T for an ambient temperature of +10 to +32 °C +16 to +32 °C +18 to +38 °C +18 to +43 °C If the refrigeration appliance is installed next to another refrigerator or freezer a clearance of 5 cm at the sides is required, in order to prevent the formation of condensation on the outside of the appliance. For correct operation this appliance must be located in a dry atmosphere, away from heat sources, e. You should also ensure that air can circulate freely around the back and the top of the cabinet. There should be 100mm (4") between the top of the cabinet and any overhanging kitchen furniture. Alternatively allow 50mm (2") between the top of the cabinet and any overhanging kitchen furniture and a gap of 25mm (1") on either side of the appliance. Alternatively a concealed spur socket fitted with a 13 A fuse may be fitted. If the outlet socket is no longer accessible after installation of the appliance, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). The mains cable may only be changed by a qualified electrician or competent person. If your appliance needs repairing, please contact your local Service Force Centre. The plug must be put into a socket with protective contact. If there is no such, it is recommended to get an electrician to fit an earthed socket in compliance with standards near the refrigerator. This appliance complies with the following E. Wash the inside of the appliance with lukewarm water with a little bicarbonate of soda added (5 ml to 0, 5 litre of water). Do not use soap or detergent as the smell may linger. Allow the appliance to stand for 2 hrs after installation. [. . . ] Clean the inside and accessories with warm water and bicarbonate of soda (5 ml to 0. Clean the drain hole of the water trough at regular intervals and ensure that the drain hole is clear at all times. If blocked carefully clear using a piece of flexible curtain wire inserted into the drain outlet to remove the blockage. Regularly check the door seals and wipe clean to ensure they are clean and free from debris. [. . . ]