User manual AEG-ELECTROLUX S17TK58

[. . . ] These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. your safety is of paramount importance. If you are unsure about the meaning of these warnings contact the Customer Care Department for assistance. [. . . ] You should also ensure that air can circulate freely around the back and the top of the cabinet. There should be 100mm (4") between the top of the cabinet and any overhanging kitchen furniture. Alternatively allow 50mm (2") between the top of the cabinet and any overhanging kitchen furniture and a gap of 25mm (1") on either side of the appliance. If your refrigerator is installed under a continuous worktop, an air outlet opening of at least 200 cm2 and a ventilation grille (A/B) matching the worktop design should be installed at the rear of the worktop. The cut surfaces of the worktop (C) should be varnished to avoid swelling due to penetration of moisture. The appliance wall distance must beat least 30 mm and should be checked before the ventilation grille is inserted. After the worktop has been removed the appliance can be installed underneath a continuous worktop. Lift the worktop slightly, push it about 20 mm towards the rear, and lift it off upwards (2). To remove the top of the refrigerator unfasten the screws on the front-right- and frontleft-hand side (3) and keep it in a safe place (4). Level the appliance by adjusting the two adjustable feet (1) at the front of the appliance. The side at which the door opens can be changed from the right side (as supplied) to the left side, if the installation site requires. When changing the side at which the door opens, the appliance must not be connected to the mains. Carefully tilt the appliance to the back and place an adequate object under it. take care to avoid the compressor or the condenser touching the ground. Unscrew both adjustable legs at the front. dismount the door holder at the bottom on the right side. For this, drive the three screws out, and pull the door holder down together with the door holder pin. Remove the screw on the left side, and drive it in on the right side. relocate the door holder pin in the door holder as per the figure. Place the door holder pin in the door at the bottom on the left side, and fix the door holder with the screw. Drive in the two adjustable front legs, and raise the appliance in the upright position. Relocate the door handle from the left side to the right, and blind the bore-holes with the plugs delivered with the appliance. [. . . ] Do not allow such substances to come into contact with appliance parts. Before any maintenance of cleaning work is carried out DISCONNECT the appliance from the ELECTRICITY SUPPLY. Clean the inside and accessories with warm water and bicarbonate of soda (5 ml to 0. Clean the drain hole of the water trough at regular intervals and ensure that the drain hole is clear at all times. [. . . ]