User manual AEG-ELECTROLUX S1850-4KS

[. . . ] j Only plug-in when machine is switched off. J Dust that arises when working on wood or using the tool on industrial material can be dangerous to health. in this case connect the tool to a suitable suction device. J Do not use cracked or distorted saw blades. [. . . ] The on-off switch is shaped in such a way that it can be used from the forward or the rear holding position. The stroke-rate (= movements per minute of the saw blade) can be infinitely varied by means of the adjustment wheel. The sawdust blower removes sawdust ahead of the cut ­ very practical when sawing along a line. The anti-splintering device almost entirely prevents the edge of the wood from splintering. The base plate can be tilted to both sides by 45o for bevel cuts. The vibration damper permits quieter running by means of a counterweight on the plunger. In the interest of continuous improvement of our products, technical specifications are subject to alteration without prior notice. The pendulum stroke of the saw blade means it is only pressed against the material on the reverse stroke (working stroke) and lifted off the material on the forward stroke. Result: better extraction of sawdust, lower friction ­> higher cutting performance. The pendulum stroke can be adjusted by the pendulum stroke control and thus adapted to different kinds of material. Always disconnect the plug from the socket before carrying out any work on the machine. Light pressure on the saw blade is sufficient to achieve the optimum rate of sawing. When cutting along a score line, use the marking on the anti-splintering device as an optical guide. To obtain a perfectly straight cut, clamp a strip of wood as a guide along the material or use the parallel guide (accessory). for cutting at an angle , or cutting a bevel , adjust the base plate. For sawing close to the edge, set the base plate at its rearmost position. to avoid vibration , clamp metal sheets onto a wooden base. To saw metal, use cooling agents along the cutting line (oil, white spirit). Plunge cuts without pre-drilling a hole are possible with soft materials (wood, light building materials for walls). Harder materials (metals) must first be drilled with a hole corresponding to the size of the saw blade. Move the base plate to the rearmost setting in order to obtain the best possible cutting angle for starting the cut. Without switching the machine on, place it with the front edge of the base plate on Switch the machine on and carefully lower the saw blade already running into the The stroke rate shown in the chart is only a suggestion for your general guidance! [. . . ] Ensure that the saw blade and the circle centre point form one single line. When working on delicate surfaces please use the plastic protection shoe. *Not included in standard equipment , available as an accessory. Fit the plastic protection shoe to the front of the base plate (as illustrated) and fix the lugs with the back of the base plate. [. . . ]