User manual AEG-ELECTROLUX S1933-6I

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/ or with signal words (Warning!, Caution!, Attention!). This symbol guides you step by step in the operation of the appliance. [. . . ] What it should never lack is good ventilation. Air is supplied under the door through the ventilation slot between the refrigerator an storage surface. Air is extracted through the upper ventilation grille. Never obstruct these openings by plinth screens or crockery. If your refrigerator is installed under a A/B continuous worktop, an air outlet 105 200 cm2 opening of at least 200 cm 2 and a ventilation grille (A/B) matching the C worktop design should be provided at 570 the rear of the worktop. The cut sur550 93-103 faces of the worktop (C) should be varnished to avoid swelling due to penetration of moisture. The appliance wall distance must be at least 30 mm and should be checked before the ventilation grille is inserted. Special accessories: A Ventilation grille, brown B Ventilation grille, white AEG36 Detaching the worktop After the worktop has been removed the appliance can be installed underneatch a continuous worktop. The procedure is as follows: Unscrew the Phillips screws (F) on the right and the left. F Lift the work-top slightly, push it about 20 mm towards the rear, and lift it off upwards (G). Unscrew the holding bracket (H) and G keep it in a safe place. H AEG56 47 Mounting under a continuous worktop If installed under a continuous worktop, the appliance is fastened with a mounting screw (A) under the panel. A AEG96 Rehingeing the door The side at which the door opens can be changed from the right side (factory adjustment) to the left side, if the installation site requires. · The appliance may not be connected to the mains during cleaning. Before cleaning switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse. · Never clean the appliance with a steam cleaner. Moisture could accumulate in electrical components, danger of electrical shock!Hot vapours can lead to the damage of plastic parts. · The appliance must be dry before it is placed back into service. · Ethereal oils and organic solvents can attack plastic parts, e. g. ­ lemon juice or the juice from orange peals; ­ butyric acid; ­ cleansers which contain acetic acid. Do not allow such substances to come into contact with appliance parts. · Do not use any abrasive cleansers. Store it in a cool place, well covered. 54 Switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse. [. . . ] Refit the light bulb cover and the screw. Put the refrigerator back into operation. AEG65 Customer Service If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department. Addresses and telephone numbers are listed in the accompanying booklet "Guarantee Conditions/Customer Service Locations". Selective ordering of replacement parts can save unnecessary travel and costs. [. . . ]