User manual AEG-ELECTROLUX S2142-4E

[. . . ] These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. INSTALLATION Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. Shelf holders Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. To remove them proceed as follows: Move the shelf retainers in the direction of the arrow, raise the shelf from the rear and push it forward until it is freed and remove the retainers. A General Safety · This appliance is designed to be operated by adults. [. . . ] Never use metal objects for cleaning your appliance as it may get damaged. · There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. Parts which heat up should not be exposed. Wherever possible the back of the product should be against a wall. · D068 Installation · During normal operation, the condenser and compressor at the back of the appliance heat up considerably. For safety reasons, minimum ventilation must be as shown in the instructions. Attention: keep ventilation openings clear of obstruction. · Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. · If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. This operstion will improve the performance of the appliance and save electricity consumption. ³1DWXUD IUHVK´ & FRPSDUWPHQW 7KH ORZHVW VKHOI GLYLGLQJ WKH FRROHU FRPSDUWPHQW IURP WKH ³1DWXUD IUHVK´ & FRPSDUWPHQW FDQ EH UHPRYHG IRU FOHDQLQJ 7R UHPRYH SXOO RXW WKH VKHOI VWUDLJKW 7KH FRYHU SODWHV DERYH WKH GUDZHUV LQ WKH & FRPSDUWPHQW FDQ EH WDNHQ RXW IRU FOHDQLQJ 7R PDNH VXUH IXOO\ IXQFWLRQDOLW\ RI WKH ³1DWXUD IUHVK´ & FRPSDUWPHQW WKH FRYHU PXVW EH SXW EDFN LQ WKHLU RULJLQDO SRVLWLRQ DIWHU FOHDQLQJ Use of the fridge Control Panel Periods of non-operation When the appliance is not in use for long periods, take the following precautions: Turn off the appliance; remove all food; defrost and clean the interior and all accessories; leave the door ajar to allow air to circulate to prevent unpleasant smells. AB C A B C D E F G On/OFF light D EFG Attention!During the stability period by the first starting the temperature displayed can not correspond to the setting temperature. During this time it is possible that the temperature displayed is lower than the setting temperature. Interior light If it becomes necessary to replace the lamp, press on the rear hook and at the same time slide the cover in the direction indicated by the arrow. Attention: Replace the lamp with one of the same power (the maximum power is shown on the light diffuser). Fridge button ON/OFF Temperature setting button (warmest) Temperature indicator Temperature setting button (coldest) Super cooling light Super cooling button D. Button ON/OFF ON: Press the button (B). During normal functioning the indicator shows the temperature inside the fridge. Difference between the temperature displayed and temperature setting is normal. Especially when: - a new setting has recently been selected - the door has been left open for a long time - warm food has been placed in the compartment Defrosting Defrosting the refrigerator compar tment is automatic. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water overflowing and dripping onto the food inside. [. . . ] The freezer is pre-set to run at -18°C. this temperature will be reached in a few hours. As soon as the appliance is switched on the temperature indicator (K) shows the current temperature inside the freezer, the alarm reset light (O) flashes and a buzzer sounds. The buzzer stops and the alarm light (O) continues to flash until the setting temperature is reached. Thawing Deep-frozen or frozen food, prior to being used, can be thawed in the refrigerator compartment or at room temperature, depending on the time available for this operation. [. . . ]