User manual AEG-ELECTROLUX S2239DT

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/or with signal words (Warning!, Caution!, Important!). This symbol guides you step by step in the operation of the appliance. [. . . ] Press in the joint covers between the appliance and the kitchen furniture. D765 9 Installation 3. Fit the appliance in the niche by making sure that it stands against the interior surface of the unit on the side where the door hinges of the appliances are fitted. Insert the appliance until the upper strip butts up against the unit (1) and make sure that the lower hinge is in line with the surface of the unit (2). 1 2 D022 4. Open the door and push the appliance against the side of kitchen furniture opposite to that of the appliance hinges. Fasten the appliance with 4 screws (I) provided in the kit included with the appliance. I 5. Snap vent grill (B) and hinge cover (E) into position. Apply blanking covers (C-D) as indicated. D C E B 6. Separate parts Ha, Hb, Hc, Hd as shown in the figure. Ha Hb Hc Hd 10 Installation 7. Place guide (Ha) on the inside part of the furniture door, upper and lower positions as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. ca. 50 mm 90° 21 m m 90° ca. on hot summer days) and a cold setting on the thermostat (position"5" to "6") can cause the compressor to run continuously. Reason: when the ambient temperature is high, the compressor must run continuously to maintain the low temperature in the appliance. The fridge will not be able to defrost since automatic defrosting of the fridge is only possible when the compressor is not running (see also "Defrosting" section). The result is the build up of a thick layer of frost on the fridge rear wall. If this happens, turn the thermostat knob back to a warmer setting (position "3" to "4"). At this setting the compressor will be switched on and off as usual and automatic defrosting recommenced. 15 Switching off the appliance To switch off the appliance, turn the temperature regulator to position "0". If the appliance is not going to be used for an extended period: 1. Switch off the appliance by turning the thermostat knob to position "0". Remove the mains plug or switch off or disconnect from the electricity supply. Clean thoroughly (see section: "Cleaning and Care"). Leave the door open to avoid the build up of odours. Interior Accessories Storage shelves Various glass storage shelves are included with your appliance. [. . . ] See the "Cleaning and Care" section. 20 Changing the light bulb Warning!Before changing the light bulb, switch off the appliance and unplug it, or disconnect from the power supply. To switch off the appliance, turn the thermostat knob to position "0". 2. To change the light bulb, undo the screw. [. . . ]