User manual AEG-ELECTROLUX S2280SILV

[. . . ] Kühl-Gefrierkombination Refrigerateur-congelateur Tweedeurs-koelkast Fridge-freezer Gebrauchsanweisung Mode d'emploi Gebruiksaanwijzing Instruction booklet 2222 031-12 CONTENTS Werning . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 27 28 28 28 28 28 29 30 30 30 30 30 31 31 31 32 32 33 33 33 33 33 33 Installation Positioning . . Starting-up and Temperature Regulation Storage of foods in refrigerator compartment . External cleaning . Periods of non-operation Replacing the interior light bulb . [. . . ] 1 100 mm PR153 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. Important It is essential that the appliance be connected to an efficient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/ 308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. A 10 mm B 10 mm NP004 Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 28 Door reversibility Before carrying out any work, remove the plug from the power socket. To change the opening direction of the doors proceed as follows: Remove the clip-in ventilation grille (D). Remove the bottom hinge (E) by unscrewing the two fixing screws. Slide the bottom door off the centre hinge (B). Remove the centre hinge and slide the top door off pin (5); unscrew pin (5) and refit it on the opposite side. Remove the two plugs, to reveal the holes for the hinge pivots, and remount them on the other side. Refit the top door and the centre hinge (H) on the opposite side. Refit bottom hinge (E) on the opposite side, using the two screws previously removed. Remove blanking cover (F) from ventilation grille (D) by pushing it in the direction of the arrow and refit it on the opposite side. Refit ventilation grille (D), clipping it into place. Refit it on the opposite side after having pierced the plugs with a punch. [. . . ] Reconnect the appliance to the power supply and then set the thermostat to the coldest position for approximately 2 hours and then shift it into the normal functioning status. Replace the foods previously removed from the freezer and the ice cubes trays. D037 The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. [. . . ]