User manual AEG-ELECTROLUX S2300KA

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/ or with signal words (Warning!, Caution!, Important!). This symbol guides you step by step in the operation of the appliance. [. . . ] The mains cable may only be changed by a qualified electrician or competent person. If your appliance needs repairing, please contact your local Service Force Centre. AEG44 Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. These buttons are connected to the temperature display. · The temperature display is switched over from the display of the ACTUAL temperature (one light illuminated) to the display of the DESIRED temperature (one light flashing) by pressing one of the two buttons, , , +" or , , -". · With each further press of one of the two buttons, the DESIRED temperature is adjusted by one display field. · If neither button is pressed, the temperature display automatically switches back after a short period (approx. 5 sec. ) to the display of the ACTUAL temperature. DESIRED temperature means: The temperature that is required in the refrigerator or freezer compartment, this can be adjusted to the temperatures shown in the display. The DESIRED temperature is indicated by a flashing light. ACTUAL temperature means: The temperature display indicates the temperature that is currently present in the refrigerator or freezer compartment. The ACTUAL temperature is indicated by a continuously illuminated light. The temperature display shows the ACTUAL refrigerator temperature. The COOLMATIC function can be ended manually at any time by pressing the COOLMATIC button again. If the COOLMATIC function is switched on the temperature setting may not be changed. Malfunctions If the electronics in the appliance have detected a fault that prevents the ACTUAL temperature being measured, the temperature display will flash. The appliance will continue to function using a backup programme until your local Service Force engineer has repaired the appliance. 14 Switching off the appliance To switch off, press the ON/OFF button until the mains power light extinguishes. If the appliance is not going to be used for an extended period: 1. Switch off the appliance by pressing the ON/OFF button until the mains power light extinguishes. Remove the mains plug or switch off or disconnect the electricity supply. Clean thoroughly (see section: "Cleaning and Care"). Leave the door open to avoid the build up of odours. Interior Accessories Storage shelves/glass shelves Various glass or plastic storage shelves and wire trays are included with your appliance - different models have different combinations. You should always slide one of the full size glass storage shelves into the lowest set of guides, above the vegetable drawers, and keep it in this position. The height of the storage shelves can be adjusted: 1. [. . . ] a period of time. Water drain hole is blocked. See the "Cleaning and Care" section. Changing the light bulb Warning!Before changing the light bulb, switch off the appliance and unplug it, or disconnect from the mains supply. To switch off, press the ON/OFF button until the mains power light extinguishes. To change the light bulb, undo the screw. [. . . ]