User manual AEG-ELECTROLUX S2330-1E

[. . . ] This information has been provided in the interests of your safety. Please read it before installing or using the appliance. Please retain the instruction book for future reference. If owner ship is transferred, please leave the user manual for the new owner. [. . . ] Do not use detergents or abrasive powders, as these will damage the finish. Remove safety elements used for transportation. Insert the plug into the wall socket and turn the thermostat knob clockwise beyond position< O > (OFF). The compressor starts and then runs automatically. To switch off the appliance, turn the temperature regulator to position < O >. The temperature regulator allows you to adjust the temperature inside the refrigerator according to use and external conditions. The following effects are of significance in respect of the interior temperature: ambient temperature quantity and temperature of the food stored; frequency with which the door is opened and how long it is left open the location of the appliance. To permit storage of food packages of various sizes, the shelves can be placed at different heights. To remove the internal shelf pull forward until it can be tipped up or down and removed. please do the same in reverse to insert the shelf at a different height. For better use of space, the front halfshelves can lie over the rear ones. At this type of appliance defrosting cooling compartment is automatic without any external intervention. The thermostatic control interrupts the operation of compressor at regular intervals for more or less time - during this cooling is interrupted - temperature of the cooling compartment increases and defrosting occurs. after defrosting the thermostatic control restarts operation of the system. Melting water flows through defrost water outlet into the evaporative tray maintained on the top of compressor and evaporates due to warmth of it. Check and clean the outlet of melting water coming during defrosting regularly. If it is clogged the melting water gathered can cause earlier failure as it can go to the insulating of the appliance. Clean the melting water outlet with the supplied pipe scraper that can be seen in the figure. The most typical case of clogging up in the defrost water outlet when you put food wrapped in some paper into the appliance and this paper contacts back plate of cooling compartment and freezes to it. If you remove the food right at this moment the paper will tear and it can cause clogging up in the outlet by getting into it. So you are asked to be careful - because of the above when placing foods wrapped in paper into the appliance. During heatwaves, the refrigerator temporarily happens to operate constantly - during this the automatic defrosting is ineffective. [. . . ] The temperature where the cabinet is placed is above normal room temperature. check that the ventilation is sufficient and that the ventilation openings are unobstructed. The cause could be the introduction of large quantities of food and/or frequent opening/closing of the door. Temperature control may cause clicking sounds when the system is connected ordisconnected. [. . . ]