User manual AEG-ELECTROLUX S2330-1KA

[. . . ] Therefore, please read the operating instructions carefully, and retain them. Above all, please take note of the safety instructions. Repairs to electrical appliances may only be performed by qualified service engineers. Improper repairs can give rise to significant hazards for the user. If the appliance is used for purposes other than those intended or used incorrectly, no liability can be accepted for any damage that may be caused. ; 1 Safety instructions The appliance operating voltage and the mains voltage must be the same! [. . . ] because a new fresh water filter discolours the water when water first flows through it. This does not spoil the taste of coffee brewed subsequently. 4 S2330-1KA. book Seite 5 Freitag, 23. Juli 1999 10:49 10 g Fill the fresh water container with cold water up to the top cup graduation. Switch on the appliance and allow the water to flow into the coffee jug without a filter paper or coffee. Pour away the water that has run through the appliance. 5. Switch on the Appliance Now switch the appliance on at the On/Off switch (Figure 1/F). After a few seconds hot water flows into the filter. Once all the water has passed through, the coffee is kept warm on the hotplate. Making Coffee 1. Fill with Water (Figure 3) Lift the lid on the fresh water container. Fill the container with clear, cold tap water. 3 You should stir the coffee in the jug so that it is of even strength. 6. Remove the Jug When the jug is removed the anti-dripvalve prevents drips falling onto the hotplate (Figure 6). The old filter can be treated as general household rubbish without cause for concern, the filter is manufactured on a vegetable base. Place the cap on the container such that the marker arrows on the cap and the container are aligned (Figure 10). Tighten the cap and insert the container such that the hooks on the container and hooks on the coffee machine mesh together, and the container is firmly seated (arrows in Figure 9). Close the lid on the fresh water filter compartment again. Fill the fresh water container and only then add the descaler not the other way round!Place the coffee jug with lid on the hotplate. (Please note that the lid of the coffee jug is used to open the antidrip-valve and must therefore be fitted for the water to flow correctly. ) Leave the descaling solution to act for approx. 15 minutes, then switch on the appliance. Once the descaling solution has run through, switch off the appliance. If necessary, repeat the descaling process. Then repeat with plain water at least twice. [. . . ] Only use the descaler in accordance with the manufacturers instructions. Coffee Jug If your coffee jug gets broken, you can purchase a replacement jug from your dealer or Electrolux Customer Service. You will need to state the model of your coffee machine; see the rating plate (Figure 1). Please retain the jug lid because replacement jugs are not supplied with lids. 6 S2330-1KA. book Seite 7 Freitag, 23. [. . . ]