User manual AEG-ELECTROLUX S2332-4KA

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/ or with signal words (Warning!, Caution!, Attention!). This symbol and numbered instructions guide you step by step in the operation of the appliance. [. . . ] An untight door seal may lead to heavy frosting and thereby to a higher power consumption (see also , , What to do if. . . "). Electrical connection Before initial start-up, refer to the appliance serial plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. 220 to 240 volts alternating current, 50 Hertz) The rating plate is inside the appliance on the left. A correctly installed, earthed socket is required for the electrical supply. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. g. fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). Attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs. on hot summer days) and a cold setting on the temperature regulator (position"5" to "6") can cause the compressor to run continuously. Reason: when the ambient temperature is high, the compressor must run continuously to maintain the low temperature in the appliance. The fridge will not be able to defrost since automatic defrosting of the fridge is only possible when the compressor is not running (see also "Defrosting" section). Always lay bottles in the shelf with the top to the front. Small bottles and cans can be placed crossways in the holder. Place only unopened bottles or cans horizontally. 37 Interior Accessories Variable Storage Box (not on all models, design differs depending on the model) Some models are equipped with a variable storage box which is fitted under a door shelf compartment and can be slid sideways. The box can be inserted under every door shelf compartment. To change, lift the shelf compartment with the box upwards and out of the holders in the door and remove the retaining bracket out of the guide under the shelf compartment. Please do the same in reverse to insert the shelf at a different height. The variable box can be hung from a storage shelf in the refrigerator compartment: 0 1. Pull the storage shelf forward until it can be tipped up or down and removed. Hang the chrome retaining bracket on the taper on the storage shelf and slide the storage shelf back into the guides. Bottle Holder (not included with all models) On some models there is a bottle holder in the bottle compartment. This is used to prevent individual bottles from falling over and can be slid sideways. 38 Correct Storage For physical reasons, there are different temperature regions in the fridge. The coldest region is on the lowest storage shelf. [. . . ] Addresses and telephone numbers are listed in the accompanying booklet "Guarantee Conditions/Customer Service Locations". Selective ordering of replacement parts can save unnecessary travel and costs. For this reason always provide the following appliance information: This information can be found on the rating plate in the interior at the · Model Name · Model Number (PNC) · Serial Number (S-No. ) left of the appliance. We recommend that you enter this information here, so that it is handy if needed. [. . . ]