User manual AEG-ELECTROLUX S2452DTW4

[. . . ] Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/or with signal words (Warning!, Caution!, Attention!). Additional information regarding operation and practical applications of the appliance appear after this symbol. Tips and notes concerning economical and environmentally sound use of the appliance are marked with the cloverleaf. Printed on paper manufactured with environmentally sound processes. who thinks ecologically acts accordingly . . . 2 Contents Safety . [. . . ] Never store lemonade, juices, beer, wine, sparkling wine etc. · All foods must be packed air tight prior to freezing, so that they do not dry out or lose their flavour, and so that no flavour contamination of other frozen goods occurs. 9 Caution!Do not touch frozen food with wet hands. To freeze fresh food rapidly, select thermostat setting 6, ensuring the temperature in the refrigerator compartment does not drop below 0°C. You should promptly reset the temperature regulator to setting "3" or "4". Place the food to be frozen in the bottom drawer. Do not open the door frequently or leave it open longer than absolutely necessary. 2. Fill the ice cube tray 3/4 full with cold water, place it in the freezer compartment and leave to freeze. To loosen the frozen cubes, either bend the ice cube tray or hold it under running water for a few seconds. Never try to free an ice tray that is frozen to the freezer compartment using pointed or sharp edged objects. Use the ice scraper supplied. Defrosting Refrigerator The refrigerator automatically defrosts every time the motor compressor stops, during normal use. (possibly after changing over the hinges). Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. At the same time shape the warmed door seal by hand such that it sits correctly. Unusual noises. Appliance is not level. The appliance is touching the wall or other objects. Readjust the feet. Move the appliance slightly. A component, e. g. a pipe, If necessary, carefully bend on the rear of the appliance the component out of the is touching another part of way. The compressor does not This is normal, no error has The compressor starts after start immediately after chan- occurred. Water on the floor or on sto- Water drain hole is blocked. See the "Cleaning and rage shelves. Care" section. Changing the light bulb Warning!Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the circuit breaker. 7. 14 To switch off the appliance, turn the temperature regulator to position "0". [. . . ] For correct air circulation, it is important that the ventilation openings are not covered or obstructed. Important: If the appliance is positioned under a kitchen wall unit, a minimum clearance of 10 cm must be left between the top of the appliance and the overhanging wall unit. 18 Rear spacers Fit the rear spacers contained in the documentation bag to ensure even dissipation of heat genereted during operation. Proceed in the sequence illustrated by the numbers in figures. 1 2 AEG68 3 AEG69 Levelling the appliance Place the appliance on a flat hard floor. Two adjustable feet on the front of the appliance enable it to be accurately levelled by screwing them in or out as required. AEG70 Reversing the door The side at which the door opens can be changed from the right side (factory fitted) to the left side. [. . . ]