User manual AEG-ELECTROLUX S2733-6I

[. . . ] SANTO 2733-6 i Integrating Fridge Freezer Operating and Installation Instructions AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www. aeg. hausgeraete. de 2222 178-84 Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] This will give you a better overview of the contents, avoid extended door opening and therefore save electricity. Installation Location The appliance should be set up in a well ventilated, dry room. Energy use is affected by the ambient temperature. The appliance should therefore ­ not be exposed to direct sunlight; ­ not be installed next to radiators or other sources of continous of heat; ­ only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed. The climate classification can be found on the rating plate, which is located at the left on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification: Climate classification SN N for an ambient temperature of +10 to +32 °C +16 to +32 °C 50 mm Your appliance needs air For safety reasons, minimum ventilation must be as shown Fig. Attention: keep ventilation openings clear of obstruction; min. cm 200 2 Ice pack D567 There is an ice pack in one drawer of the freezer. In the event of a power failure or malfunction, the ice pack will lengthen the amount of time it takes for the frozen food to become too warm by several hours. The ice pack can only fulfil this task efficiently if it is placed in the uppermost drawer, at the front, above the frozen food. You can use the ice pack for cooling cold bags. Reversing the door The side the door opens can be changed from the right side (factory adjustment) to the left side, if the installation site requires. When changing the side the door opens, the appliance must not be connected to the mains. Remove plug from the mains beforehand. Preparation of Ice Cubes 1. 10 Fill the ice cube tray 3/4 full with cold water, place it in the freezer compartment and leave to freeze. 19 Installation Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. 2. To loosen the frozen cubes, either twist the ice cube tray or hold it under running water for a few seconds. Never try to free an ice tray that is frozen to the freezer compartment using pointed or sharp edged objects. Use the ice scraper supplied. WARNING ­ THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left. The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. Frozen food Symbols/Freezing Calendar · The symbols on the drawers show different types of frozen goods. · The numbers indicate storage times in months for the appropriate types of frozen goods. Whether the upper or lower value of the indicated storage time is valid depends on the quality of the foods and pre-treating before freezing. The lower value applies to foods with high fat content. · By attaching the included index-tabs to the drawers, they can be marked according to which type of foods the individual compartments contain. Important! The wires in the mains lead are coloured in accordance with the following code: Green and Yellow Earth Blue Neutral Brown Live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. [. . . ] The cold in the frozen food will then be used to cool the fridge. Symptom Possible Cause Remedy Something Not Working If the appliance is not functioning correctly, please carry out the following checks before contacting your local AEG Service Force Centre. Heavy build up of frost, pos- Door seal is not air tight Carefully warm the leaking sibly also on the door seal. (possibly after reversing the sections of the door seal door). with a hair dryer (not hotter than approx. At the same time shape the warmed door seal by hand until it sits correctly. [. . . ]