User manual AEG-ELECTROLUX S3630KG

[. . . ] For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. This information has been provided in the interests of your safety. Please read it before installing or using the appliance. Please retain the instruction book for future reference. [. . . ] Wait 4 hours before connecting the appliance to allow the oil to flow back in the compressor. Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Remove safety elements used for transportation. Insert the plug into the wall socket and turn the thermostat knob clockwise beyond position «O» (OFF). The following effects are of significance in respect of the interior temperature: Ambient temperature Quantity and temperature of the food stored; Frequency with which the door is opened and how long it is left open the location of the appliance. To permit storage of food packages of various sizes, the shelves can be placed at different heights. To remove the internal shelf pull forward until it can be tipped up or down and removed. please do the same in reverse to insert the shelf at a different height. The glass shelf above the vegetable drawers and the bottle shelf should always remain in position, to ensure correct air circulation. To permit storage of food packages of various sizes, the central door shelf can be adjusted in height. The thermostatic control interrupts the operation of compressor at regular intervals for more or less time - during this cooling is interrupted temperature of the cooling compartment increases and defrosting occurs. after defrosting the thermostatic control restarts operation of the system. Melting water flows through defrost water outlet into the evaporative tray maintained on the top of compressor and evaporates due to warmth of it. Check and clean the outlet of melting water coming during defrosting regularly. If it is clogged the melting water gathered can cause earlier failure as it can go to the insulating of the appliance. Clean the melting water outlet with the supplied pipe scraper that can be seen in the figure. The most typical case of clogging up in the defrost water outlet when you put food wrapped in some paper into the appliance and this paper contacts back plate of cooling compartment and freezes to it. If you remove the food 30 Right at this moment the paper will tear and it can cause clogging up in the outlet by getting into it. So you are asked to be careful - because of the above - when placing foods wrapped in paper into the appliance. During heatwaves, the refrigerator temporarily happens to operate constantly - during this the automatic defrosting is ineffective. Remaining small ice and frost stains on back plate of the cooling compartment after defrosting period is not abnormal. [. . . ] Make sure that the door is completely closed and that the insulating strip is complete and clean. The temperature where the cabinet is placed is above normal room temperature. It is too cold inside the Turn the temperature regulator to a warmer setting temporarily. The compressor works Turn the thermostat knob to a lower number. [. . . ]