User manual AEG-ELECTROLUX S60150TK

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and/ or with signal words (Warning!, Caution!, Important!). This symbol guides you step by step in the operation of the appliance. [. . . ] Remove plug from the mains beforehand. 1. Unscrew the door hinge (A) and screw it into place on the opposite side. Tilt the appliance slightly towards the rear and prop it securely. Unscrew the door hinge screws (K) and remove the hinge pin bracket (1). 1 K AEG97 6. Refit it on the opposite side after having pushed in the plugs with a punch. Cover the holes left open with the plugs contained in the documentation pack. 70 Installation Electrical Connection The plug socket necessary for connection of your appliance to the electricity supply should be positioned so that it is possible to pull out the appliance plug. If your appliance is installed under a continuous worktop, the plug socket should be provided as shown. Alternatively a concealed spur socket 130 fitted with a 13 A fuse may be fitted. If the socket is not accessible once the appliance is built in, the electrical 300 installation must include suitable means of isolating the appliance from the mains (e. g. fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). Before initial start-up, refer to the appliance serial plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. To change, lift the shelf compartment with the box upwards and out of the holders in the door and remove the retaining bracket out of the guide under the shelf compartment. Please do the same in reverse to insert the shelf at a different height. The variable box can be hung from a storage shelf in the refrigerator compartment: 1. Pull the storage shelf forward until it can be tipped up or down and removed. Hang the retaining bracket on the taper on the storage shelf and slide the storage shelf back into the guides. Correct storage For physical reasons, there are different temperature regions in the fridge. The coldest region is on the lowest storage shelf. Warmer regions are the top storage shelf, the vegetable drawer and the storage compartments on the door. The arrangement example shows at which places in the refrigerator suitable temperatures for various types of foods exist. 76 Tip: Food in the fridge should always be covered or packaged, to prevent drying and tainting of other food. The following are suited for packaging: ­ Polyethylene airtight bags and wraps; ­ Plastic containers with lids; ­ Special plastic covers with elastic; ­ aluminium foil. Defrosting The fridge defrosts automatically The rear wall of the fridge covers with frost when the compressor is running, and defrosts when the compressor is off. The water from the thawing frost is collected in the drain channel on the rear of the fridge, feed through the drain hole into the collector on the compressor, and then evaporated. The water drainage hole must be cleaned regularly (see the section "Cleaning and Maintenance"). Cleaning and Care For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly. [. . . ] Refit the light bulb cover and the screw. Put the refrigerator back into operation. AEG65 Customer Service If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department. Addresses and telephone numbers are listed in the accompanying booklet "Guarantee Conditions/Customer Service Locations". Selective ordering of replacement parts can save unnecessary travel and costs. [. . . ]