User manual AEG-ELECTROLUX S61290DT0

[. . . ] If you plan to idle the unit for a long time. Operate the fan for about half a day to dry the inside of the unit. Stop the air conditioner and disconnect the power source. Remo the batteries from the remote controller. [. . . ] If the air conditioner operates in excess of this figure, the surface of the air conditioner may attract condensation. Please set the vertical air flow louver to its maximum angle (vertically to the floor), and set HIGH fan mode. ~ 43 C ~ 24 C ~ 11 C ~ 17 C 32 C 43 C REMOTE CONTROLLER Refer to REMOTE CONTROLLER MANUAL. TEMPORARY OPERATION NORMAL OPERATION This function is used to operate the unit temporarily in case you misplace the remote controller or its batteries are exhausted. Open the panel and lift it up to a position angle where it remains fixed. 2 Turn the switch to AUTO position and the air conditioner will run under AUTO mode. 3 Close the panel firmly to its original position. 1 Temporary switch The batteried in the remote controller Change the batteries are exhausted. The temperature setting is too high or too low. Does not cool or heat well The air filter is clogged with dust The air inlet or outlet of the outdoor unit is blocked Doors or windows are open Does not cool or heat at all The air inlet or outlet of the outdoor unit is blocked Three-minute protection feature Inappropriate temperature setting Wait or cancel timer setting Set at a more comfortable temperature. Clean the filter Clear up the block Close the doors or windows Clear up the block first, then begin to operate. Wait for a while Set the temperature properly COOL AUTO CAUTION: Remote control function can't be used while the Indoor unit is in AUTO operation. If you want to use remote control function, please press AUTO switch on Indoor Unit Control Panel again. COOL switch on the Control Panel is only used in Test Operation. If a problem still exists, please contact your dealer. Do not allow young children to operate this unit. 3 4 OWNERSMANUAL ' REMOTE CONTROLLER R51/E-30 Warning 1. Be sure there are no barriers between the remote controller and the receiver of indoor unit otherwise the air conditioner will not work. Keep the Remote Controller away from all liquids. Protect the Remote Controller from high temperatures and exposure to radiation. Keep the indoor receiver out of direct sunlight or the Air Conditioner may malfunction. Keep controller away from EMI (Electro-Magnetic Interference) supplied by other household appliances. CONTENTS Remote Controller Specifications---------------------------------------1 Performance Features----------------------------------------------------- 1 Introduction of Function Buttons on the Remote Controller--1 Names and Functions of indicators on Remote Controller---- 3 Operating the Remote Controller---------------------------------------4 Warning--------------------------------------------------------------------------7 7 Remote Controller Specifications Model Rated Voltage Lowest Voltage of CPU Emitting Signal Reaching Distance Environment Temperature Range R51, R51/BG, R51/E, R51/CE, R51/BGE, R51/CBGE 3. 0V 2. 0V 8m (when using 3. 0 voltage, it Gets 11m) -5 C 60 C 2. 2. 1 Please press the CANCEL button to cancel any former settings. 2. 2 Push the TIMER button and the remote controller will show the last set time for the START operation and the signal "h" will be shown on the display panel. You are now ready to readjust the TIMER OFF to stop the operation. 2. 3 Push the TEMP button to cancel the TIMER ON setting. The digital area will show "00". [. . . ] To replace the old batteries , use the same method as mentioned above. AUTO COOL DRY HEAT FAN HIGH MED LOW NOTE 1. When replacing batteries, do not use old batteries or a different type battery. This may cause the remote controller to malfunction. If you do not use the remote controller for several weeks remove the batteries. [. . . ]