User manual AEG-ELECTROLUX S64160TK38

[. . . ] Before switching on your new appliance please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] take care to avoid the compressor or the condenser touching the ground. Unscrew the adjustable feet situated on both sides (2 pieces), in addition the screws fixing the lower door holders (2 pieces) respectively the screw on the other side. take off the freezer door by pulling it slightly downwards. Unscrew the top door hinge pin of the refrigerator then screw it back on the other side. fit the freezer door on the upper door hinge pin. Put over the pin in the lower door holding plate in the direction of the arrow. Fix the plate on the other side leaving the position of the door unchanged. Then screw in the one screw in the place set free on the other side as well as the adjustable feet (2 pieces) and stand upright again. Put the handles on the other side and put the plastic covering pins supplied in the plastic bag of this instruction book into the vacant holes. Put the appliance into it's place, set it level and plug it into the mains socket. After reversing the refrigerator door, it is necessary to reverse the door of the frozen food compartment as well. Press the retaining lever inside the lower door hinge 2. Tilt the lower door hinge out together with the freezer compartment door then remove it from the pin of the freezer compartment door. Remove the rectangular plug and put it into the opening got free on the other side. Having the freezer compartment door turned by 180° put the lower hinge onto the lower pin of the freezer compartment door. Put the upper hinge pin of the freezer compartment door into the free opening, then push the lower hinge into its place together with the freezer compartment door. The plug socket necessary for connection of your appliance to the electricity supply should be positioned so that it is possible to pull out the appliance plug. If your appliance is installed under a continuous worktop, the plug socket should be provided as shown. Alternatively a concealed spur socket fitted with a 13 A fuse may be fitted. If the outlet socket is no longer accessible after installation of the appliance, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). The mains cable may only be changed by a qualified electrician or competent person. [. . . ] Carefully warm the leaking sections of the Heavy build up of frost, Door seal is not airtight door seal with a hair dryer possibly also on the door (possibly after reversing (on a cool setting). Appliances The appliance is touching Move the the wall or other objects. The compressor does not This is normal, no error The compressor starts start immediately after has occurred. Should the light fail to work you can change it as below: Disconnect the appliance from the electricity supply. [. . . ]