User manual AEG-ELECTROLUX S70338KA1

[. . . ] Thank you for choosing one of our high-quality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best performance and control - indeed we are setting the highest standards of excellence. In addition to this you find environmental and energy saving aspects as an integral part of our products. [. . . ] The appliance should therefore ­ not be exposed to direct sunlight; ­ not be installed next to radiators, cookers or other sources of heat; ­ only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed. The climate classification can be found on the serial plate, which is located at the left on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification: each climate classification: Climate classification SN N ST T If installation next to a source of heat is unavoidable, the following minimum clearances must be maintained at the sides of the appliance: ­ for electric cookers 3 cm; ­ for oil and coal fired ranges 30 cm. If these clearances cannot be maintained a heat insulating pad is required between the cooker and the refrigeration appliance. If the refrigeration appliance is installed next to another refrigerator or freezer a clearance of 5 cm at the sides is required, in order to prevent the formation of condensation on the outside of the appliance. These buttons are connected to the temperature display. The temperature display is switched over from the display of the ACTUAL temperature (Temperature display is illuminated) to the display of the DESIRED temperature (Temperature display flashes) by pressing one of the two buttons, "C" (+) or "E" (-). Each time one of the two buttons is pressed again the DESIRED temperature is adjusted by 1 °C. The DESIRED temperature must be reached within 24 hours. If neither button is pressed, the temperature display automatically switches back after a short period (approx. The temperature display can indicate several pieces of information. During normal operation, the temperature currently present in the fridge (ACTUAL temperature) is displayed. When the temperature is being adjusted a flashing display indicates the fridge temperature currently set (DESIRED temperature). The temperature display will immediately show the changed setting. each time the button is pressed the temperature is adjusted by 1 °C. From a food safety point of view +5 °C should be considered sufficiently cold for storing food in the fridge. Once the required temperature has been set, after a short period (approx. ) the temperature display will change and again indicate the current ACTUAL temperature inside the fridge. When the setting is changed, the compressor does not start immediately if automatic defrosting is currently taking place. As the storage temperature within the fridge is reached quickly you can store food immediately after switching on. The COOLMATIC function is suited for quick cooling of large quantities of goods in the refrigerator. The COOLMATIC function is ended automatically after a period of 6 hours. [. . . ] Before cleaning switch the appliance off and remove the plug from the mains, or switch off or turn out the circuit breaker or fuse. ⷠNever clean the appliance with a steam cleaner. The appliance must be dry before it is placed back into service. Ethereal oils and organic solvents can attack plastic parts, e. [. . . ]