User manual AEG-ELECTROLUX S70338WK

[. . . ] Thank you for choosing one of our high-quality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best performance and control - indeed we are setting the highest standards of excellence. In addition to this you find environmental and energy saving aspects as an integral part of our products. [. . . ] Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs. These buttons are connected to the temperature display. The temperature display is switched over from the display of the ACTUAL temperature (Temperature display is illuminated) to the display of the DESIRED temperature (Temperature display flashes) by pressing one of the two buttons, "C" (+) / "C" (-) or "E" (+) / "E" (-). Each time one of the two buttons is pressed again the DESIRED temperature is adjusted by 1 °C. The DESIRED temperature must be reached within 24 hours. If neither button is pressed, the temperature display automatically switches back after a short period (approx. The temperature display can indicate several pieces of information. During normal operation, the temperature currently present in the compartment. When the temperature is being adjusted a flashing display indicates the compartment temperature currently set (DESIRED temperature). The temperature display will immediately show the changed setting. each time the button is pressed the temperature is adjusted by 1 °C. Once the required temperature has been set, after a short period (approx. ) the temperature display will change and again indicate the current ACTUAL temperature inside the fridge. An acoustic alarm sounds when the door remains open for about 5 minutes. The acoustic signal goes off when normal conditions are restored (door closed). In the case you want to maintain the light on with the door closed, it is sufficient to open and close the door and the light will remain ON automatically for 10 minutes. If you want to switch off the light before the automatic turn off time, open the door and push the switch button (H) The light indicator "G" will switch off. [. . . ] Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. To switch off, hold down the ON/OFF button for approx. This will result in a countdown from "3" to "1" taking place in the temperature display. [. . . ]