User manual AEG-ELECTROLUX S71330DT1

[. . . ] SANTO 71330-1 DT Refrigerador-congelador Fridge freezer Refrigerador-congelador Instruções de utilização Operating Instructions Instrucciones de uso AEG Hausgeräte GmbH Postfach 1036 D-90327 Nürnberg http://www. aeg. hausgeraete. de © Copyright by AEG 2223 398-91 03/06 Con reserva de modificaciones Subject to change without notice Sujeito a alterações sem aviso prévio Dear customer, Before placing your appliance into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] At the same time shape the warmed door seal by hand such that it sits correctly. The appliance is touching the wall or other objects. a pipe, on the rear of the appliance is touching another part of the appliance or the wall. The compressor does not start This is normal, no error has immediately after changing occurred. Water on the floor or on sto- Water drain hole is blocked. If necessary, carefully bend the component out of the way. The compressor starts after a period of time. See the "Cleaning and Care" section. If installation next to a source of heat is unavoidable, the following minimum clearances must be maintained at the sides of the appliance: ­ for electric cookers 3 cm; ­ for oil and coal fired ranges 30 cm. If these clearances cannot be maintained a heat insulating pad is required between the cooker and the refrigeration appliance. If the refrigeration appliance is installed next to another refrigerator or freezer a clearance of 5 cm at the sides is required, in order to prevent the formation of condensation on the outside of the appliance. 38 27 Your appliance needs air For safety reasons, minimum ventilation must be as shown Fig. Attention: keep ventilation openings clear of obstruction; 100 mm 6. 7. Accumulation of dust at the condenser increases energy consumption. For this reason carefully clean the condenser at the back of the appliance once a year with a soft brush or a vacuum cleaner. Check the water drain hole on the rear wall of the fridge. Clear a blocked drain hole with the aid of the green peg included with the appliance. After everything is dry place appliance back into service. Energy Saving Tips 10 mm 10 mm NP005 Rear spacers In the bag with the documentation, there are two spacers which must be fitted. Slacken the screws and insert the spacer under the screw head, then re-tighten the screws. Rehingeing the door PR153 The side at which the door opens can be changed from the right side (factory adjustment) to the left side, if the installation site requires. When changing the side at which the door opens, the appliance may not be connected to the mains. Remove plug from the mains beforehand. · Do not install the appliance near cookers, radiators or other sources of warmth. High ambient temperatures cause longer, more frequent operation of the compressor. · Ensure sufficient air circulation and exhaust at the appliance base and at the back wall of the appliance. · Do not place warm foods into the appliance. [. . . ] It is suggested that the fan (D. A. C. ) be used when the ambient temperature exceeds 25°C . It should be remembered that the thermostat knob must be placed (see fig. 2) SWITCH Fresh food refrigeration To obtain the best performance: · do not store warm food or evaporating liquide in the refrigeator · do cover or wrap the food, particularly if it has a strong flavour. · Position food so that air can circuiate freely round it. Useful hints: Meat (all types): wrap in polythene bags and place on the glass shelf above the vegetable drawer(s)For safety, store in this way only one or two days at the most. [. . . ]