User manual AEG-ELECTROLUX S71390KA6

[. . . ] Thank you for choosing one of our high-quality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best performance and control - indeed we are setting the highest standards of excellence. In addition to this you find environmental and energy saving aspects as an integral part of our products. [. . . ] Reposition, level the appliance, wait for at least one hour and then connect it to the mains socket. In any case you do not want to carry out the above mentioned operations, contact the nearest After Sales Service Force. The After Sales Service specialist will carry out the reversibility of the doors at your cost. Attention: After having reversed the opening direction of the doors check that all the screws are properly tightened and that the magnetic seal adheres to the cabinet. In Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs. These buttons are connected to the temperature display. The temperature display is switched over from the display of the ACTUAL temperature (Temperature display is illuminated) to the display of the DESIRED temperature (Temperature display flashes) by pressing one of the two buttons, , , B" or , , D" . Each time one of the two buttons is pressed again the DESIRED temperature is adjusted by 1 °C. The DESIRED temperature must be reached within 24 hours. If neither button is pressed, the temperature display automatically switches back after a short period (approx. The temperature display can indicate several pieces of information. During normal operation, the temperature currently present in the fridge (ACTUAL temperature) is displayed. When the temperature is being adjusted a flashing display indicates the fridge temperature currently set (DESIRED temperature). The temperature display will immediately show the changed setting. each time the button is pressed the temperature is adjusted by 1 °C. [. . . ] Keep the heat emitting condenser, the metall grille on the rear wall of your appliance, always clean. A malfunction may be caused by only a minor fault that you can rectify yourself using the following instructions. Do not perform any other work on the appliance if the following information does not provide assistance in your specific case. Improper repairs can give rise to significant hazards for the user. [. . . ]