User manual AEG-ELECTROLUX S7380KG

[. . . ] SANTO 7380KG SANTO 7388KG Fridge Freezer Operating and Installation Instructions Congratulations on the purchase of your new refrigerator. With proper care, it will provide you with many years of dependable operation. Please read this Use and Care manual completely before operating your refrigerator. It contains the necessary information to ensure safe, efficient operation. [. . . ] If cartridge remains in housing, pull down gently, while twisting filter back and forth. It is not necessary to turn the water supply off to change filter. Set ice maker lever (wire signal arm) to the OFF (up) position. Push the Filter Release Button, located to the right of the filtre cartridge, to release the filter from the housing. NOTE: A small amount of water may be releasedduring this operation. To minimize the possibility of the filter falling out of the housing during removal, it would be best to hold the filter as it moves out toward you. Pull the old filter cartridge straight out of the housing. Replace new cartridge, installing the same way as the old one came out. When the cartridge is almost in, you will feel it stop against the clip assembly in the back of the housing. The clip assembly holds the filter cartridge firmly in place. At this point, you will need to push firmly until the cartridge snaps fully in place. When completely in place, the front of the filter cartridge will be flush with the front of the housing. Set the ice maker wire signal arm to the ON (down) position. There will be noticable spurts and sputters as the system pushes the air out through the system and out the dispenser nozzle. After you have run one glass of water, continue to flush the system for approximately 3 minutes. Resetting The Filter Status Light (some models) After replacing the filter cartridge, it will be necessary to press the Filter Reset touchpad located on the ice and water dispenser. This will reset the Change Filter Indicator. Push the reset button until the green light flashes (3-15 seconds). Filter Cartridge Automatic Ice Maker OPERATION OF AUTOMATIC ICE MAKER (Some Models) If your refrigerator has an automatic ice maker, it will provide a continuous supply of ice. If not factory installed, the ice maker can be purchased as an accessory kit from your dealer. 220-240V, 50/60 Hz models use ice maker kit number IM220. This ice maker kit must be installed by a qualified technician only. CAUTION: Ensure that the ice maker water supply tube is connected to a safe (potable) water pipe only. CAUTION: Water supply must have minimum pressure of 1. 4 bars (20 psi) and maximum water pressure of 6. 9 bars (100 psi). [. . . ] Adjust settings as necessary. TO REMOVE FREEZER DOOR: 1. Disconnect water line at lower hinge on freezer door: grip water tube firmly in one hand, then with 3/8" wrencn, push in on gray collar to release water connector. Remove top hinge cover screw on freezer door and remove cover. Disconnect wiring harness connector plug at top hinge: place your thumbs on flat side of each connector and bend both parts back and forth, then with firm grip, pull both pieces apart. [. . . ]