User manual AEG-ELECTROLUX SANTO 1630 I

[. . . ] These operating instructions are for use with several technically comparable models with varying accessories. Please observe the notes which apply to your model. 1 Notes which are important for your safety or for the correct functioning of the appliance are indicated with a warning triangle and/ or the words (Warning!, Caution!, Important!). Please observe the information carefully. 0 This symbol guides you step by step in the operation of the appliance. 3 2 Additional information regarding operation and practical use of the appliance appear after this symbol. [. . . ] An untight door seal may lead to heavy frosting and thereby to a higher power consumption (see also , , Something not working"). 9 Installation Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. 1 WARNING ­ THIS APPLIANCE MUST BE EARTHED The manufacturer declines any liability should these safety measures not be observed. Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The rating plate is inside, on the left. The appliance is supplied with a 13 amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used. Important The wires in the mains lead are coloured in accordance with the following code: Green Green and Yellow Earth & Yellow Blue Neutral Brown Live As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings indentifying the terminals Blue Brown in your plug, proceed as follows: 1. The wire coloured green and yellow must be connected to the terminal marked with the letter Cord Clamp , , E" or by the earth symbol or coloured green and yellow. The wire coloured blue must be connected to the terminal , , N" or coloured black. The wire coloured brown must be connected to the terminal marked , , L" or coloured red. Upon completion there must be not cut, or stray strands of wire present and the cord clamp must be secure over the outer sheat. 1 10 Warning!A cut-off plug inserted into a 13 amp socket is a serious safety (shock) hazard. · Do not use detergents, abrasive powders, highly perfumed cleaning products, wax polishes or cleaning products containing bleach or alcohol. 0 Clean the drain hole of the water through at regular intervals and ensure that the drain hole is clear at all times. If blocked, carefully clear using a piece of flexible curtain wire inserted into the drain outlet to remove the blockage. 0 Regularly check the door seals and wipe clean to ensure they are clean and free from debris. External Cleaning 0 Wash the outer cabinet with warm soapy water. 1 Warning!· Do not use abrasive products · There are sharp edges on the underside of the product so care should be taken when cleaning. Replacing the light bulb 1 0 0 0 0 0 Warning!Ensure the appliance is disconnected from the mains supply. Light bulb specifications: 220-240 V, max. 15 W, socket: E 14 To switch the appliance off turn the temperature regulator to position "0" . To change the light bulb, remove the screw and the light bulb cover as shown. Refit the light bulb cover and the screw. 3 17 Something not Working Before contacting your local Service Force Centre, check the following points. Symptom Solution Check there is power at the socket No power to the appliance. Check there is not a power cut by checking the household lights. [. . . ] Please note that proof of purchase is required for in-guarantee service calls. Service & Spare Parts If you require a service engineer or wish to purchase spare parts, contact your local AEG Service Force Centre, by telephoning 08705 929 929 Help us to help you Please determine your type of enquiry before telephoning. The model, production number and product identification number. This information can be found on the rating plate, so you have these numbers to hand we recommend you write them below. [. . . ]