User manual AEG-ELECTROLUX SANTO 1673-4TK

[. . . ] ÖKO-SANTO SUPER 1673-4 TK Automatic Larder Operating Instructions Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] Lift the worktop slightly, push it about 20 mm towards the rear, and lift it off upwards (G). G Unscrew the holding bracket (H) and H keep it in a safe place. AEG56 8 Mounting under a continuous worktop If installed under a continuous worktop, the appliance is fastened with a mounting screw (A) under the panel. A AEG96 Rehingeing the door The side at which the door opens can be changed from the right side (as supplied) to the left side, if the installation site requires. When changing the side at which the door opens, the appliance may not be connected to the mains. 3. The wire coloured brown must be connected to the terminal marked "L" or coloured red. 4. Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath. A cut-off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that the cut-off plug is disposed of safety. Plug socket The plug socket necessary for connection of your appliance to the electricity supply should be positioned so that it is possible to pull out the appliance plug. If your appliance is installed under a continuous worktop, the plug socket should be provided as shown. A concealed spur socket requires 10 A/16 A fusing. AEG44 130 300 If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. g. fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). 11 Starting up and temperature regulation Insert the plug of the connection lead into the plug socket with protective earth contact. When the refrigerator compartment door is opened, the internal lighting is switched on. The temperature selector knob is located on the RH side of the refrigerator compartment. Turning clockwise in direction "1": Refrigerating unit on, the latter then operating automatically. Setting "1" means: Hightest temperature, warmest setting. Setting "6" (end-stop) means: Lowest temperature, coldest setting. AEG62 At a low ambient temperature of around 16°C, setting "1" should be selected. At ambient temperatures of around 25°C, select setting "2". If you require a lower temperature, select setting "3" or "4". on hot summer days) and a cold setting on the temperature regulator (position"5" to "6") can cause the compressor to run continuously. Reason: when the ambient temperature is high, the compressor must run continuously to maintain the low temperature in the appliance. The fridge will not be able to defrost since automatic defrosting of the fridge is only possible when the compressor is not running (see also "Defrosting" section). The result is the build up of a thick layer of frost on the fridge rear wall. If this happens, turn the temperature regulator back to a warmer setting (position "3" to "4"). [. . . ] Please look in the "Installation location" section. Please look in the "Changing the Light Bulb" sections. Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than approx. At the same time shape the warmed door seal by hand such that it sits correctly. Appliance does not work. Appliance cools too much. The food is too warm. Interior lighting does not work. Heavy build up of frost, possibly also on the door seal. Door seal is not air tight (possibly after changing over the hinges). 17 Malfunction Possible Cause Appliance is not level. [. . . ]