User manual AEG-ELECTROLUX SANTO 2992-6I

[. . . ] Santo 2992-6 i Integrating Fridge Freezer no-frost Operating and Installation Instructions Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] The defrost water drains out through a trough into a special contain11 er at the back of the appliance, over the motor compressor, where it evaporates. We particulary recommend that you peridically clean the defrostwater drainage outlet, located in the center of the drainage groove in the refrigerator compartment, to prevent the defrost water form overflowing on to foods stored in the compartment. Use a special cleaner provided, which you will find already inserted into the discharge hole. Freezer The inner walls of the freezer are automatically defrosted Switching off the appliance To switch off the appliance, turn the temperature regulator to position "0" or disconnect from the electricity supply. If the appliance is not going to be used for an extended period: Remove all refrigerated and deep-frozen packages as well as ice trays. Clean and dry thoroughly (see section: Cleaning and Care). Leave the door open to avoid the build up of odours. 1. 4. Cleaning and Care For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly. Warning! Before carrying out any cleaning or maintenance, disconnect the appliance from the electricity supply. Never clean the appliance with a steam cleaner. Moisture could accumulate in electrical components, danger of electrical shock!Hot vapours can lead to the damage of plastic parts. The appliance must be dry before it is placed back into service. Warning! Ethereal oils and organic solvents can attack plastic parts, e. g. 12 lemon juice or the juice from orange peel, butyric acid; cleansers which contain acetic acid. Do not allow such substances to come into contact with appliance parts. Remove frozen food and the food from the refrigerator. Wrap frozen food in several layers of newspaper. Switch the appliance off and remove the plug from the mains, or disconnect from the electricity supply. Clean the appliance and the interior accessories with lukewarm water with a little bicarbonate of soda added (5ml to 0, 5 litre of water). Check the water drain hole on the rear wall of the fridge. Clear a blocked drain hole with the aid of the drain cleaning tool included with the appliance. When everything is dry place appliance back into service. 4. 5. 6. Energy Saving Tips Do not install the appliance near radiators or other sources of continuous warmth. High ambient temperatures cause longer, more frequent operation of the compressor. Ensure sufficient air circulation and exhaust at the appliance base and at the back wall of the appliance. [. . . ] 4. 18 Installation Location The appliance should be set up in a well ventilated, dry room. Energy use is affected by the ambient temperature. The appliance should therefore not be exposed to direct sunlight; not be installed next to radiators or other sources of continuous heat; only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed. The climate classification can be found on the serial plate, which is located at the left on the inside of the appliance. [. . . ]