User manual AEG-ELECTROLUX SANTO 3244-4I

[. . . ] ÖKO - SANTO 3244-4 i Integrating Fridge Freezer Operating and Installation Instructions Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] If the appliance is not going to be used for an extended period: Remove all refrigerated and deep-frozen packages as well as ice trays. Defrost freezer compartment and clean thoroughly (see section: "Cleaning and Care"). Leave the door open to avoid the build up of odours. 1. 4. Cleaning and Care For hygienic reasons the appliance interior, including interior accessories, should be cleaned regularly. Warning! Before carrying out any cleaning or maintenance, disconnect the appliance from the electricity supply. · Never clean the appliance with a steam cleaner. Moisture could accumulate in electrical components, which could cause an electrical shock!Hot vapours can lead to the damage of plastic parts. · The appliance must be dry before it is placed back into service. Warning! · Ethereal oils and organic solvents can attack plastic parts, e. g. ­ lemon juice or the juice from orange peel, ­ butyric acid; ­ cleansers which contain acetic acid. Do not allow such substances to come into contact with appliance parts. · Do not use any abrasive cleansers. Remove frozen food and the food from the refrigerator. Wrap frozen food in several layers of newspaper. Switch the appliance off and remove the plug from the mains, or switch off. Clean the appliance and the interior accessories with lukewarm water and with a little bicarbonate of soda added (5ml to 0, 5 litre of water). 12 4. Check the water drain hole on the rear wall of the fridge. Clear a blocked drain hole with the aid of the drain cleaning tool included with the appliance. When everything is dry place the appliance back into service. 6. D037 Energy Saving Tips · Do not install the appliance near radiators or other sources of continuous warmth. High ambient temperatures cause longer, more frequent operation of the compressor. · Ensure sufficient air circulation at the appliance base and at the back wall of the appliance. · Do not place warm foods into the appliance. · Do not leave the door open any longer than necessary. [. . . ] The appliance should therefore ­ not be exposed to direct sunlight; ­ not be installed next to radiators or other sources of continuous heat; ­ only be installed at a location whose ambient temperature corresponds to the climate classification, for which the appliance is designed. The climate classification can be found on the rating plate, which is located at the left on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification: Climate classification SN N for an ambient temperature of +10 to +32 °C +16 to +32 °C 50 mm Your appliance needs air For safety reasons, minimum ventilation must be as shown Fig. Attention: keep ventilation openings clear of obstruction; min. [. . . ]