User manual AEG-ELECTROLUX SANTO D 4 12 40-6I

[. . . ] Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] Fix cover (Hc) on guide (Ha) until it clips into place. Insert the small square (Hb) into guide (Ha). Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K). Place the small square on the guide again and fix it with the screws supplied. Should the lining up of the furniture door be necessary, use the clearance of slots. Fix cover (Hd) on guide (Hb) until it clips into place. The doors can be opened using the sliding system previously illustrated, or one of the two doors can be opened by fitting the small handle supplied as an accessory. Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs. However, the exact setting should be chosen keeping in the mind that the temperature inside the refrigerator depends on: -the quantity of food stored -how often the door is opened The temperatures in the refrigerator compartment and freezer co partment cannot be independently regulated. If you want the freeze fresh food rapidly, select setting , , 6", ensuring that the temperature in the refrigerator compartment does not drop blow 0°C. On hot summer days) and a cold setting on the temperature regulator (position"5" to "6") can cause the compressor to run continuously. If this happens, turn the temperature regulator back to a warmer setting (position "3" to "4"). At this setting the compressor will be switched on and off as usual and automatic defrosting recommenced. The glass shelf above the fruit and vegetable compartment should always remain in position, to ensure fruit and vegetables stay fresh longer. The remaining storage shelves can be adjusted to various heights: D338 Pull the storage shelf forward until it can be tipped up or down and removed. To insert at a different height use the same procedure in reverse. The door compartments can be pulled up and removed, and inserted at other positions as needed. [. . . ] After everything is dry place applianD037 ce back into service. Do not install the appliance near cookers, radiators or other sources of warmth. High ambient temperatures cause longer, more frequent operation of the compressor. Do not place warm foods into the appliance. [. . . ]