User manual AEG-ELECTROLUX SANTO K 8 12 03-6I

[. . . ] Thank you for choosing one of our high-quality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best performance and control - indeed we are setting the highest standards of excellence. In addition to this you find environmental and energy saving aspects as an integral part of our products. [. . . ] A badly fitting door seal may lead to heavy frosting and thereby to a higher power consumption (see also , , What to do if. Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. To remove them proceed as follows: Move the shelf holders in the direction of the arrow, raise the shelf from the rear and push it forward until it is freed and remove the retainers. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. This makes it is more difficult to change the temperature setting accidentally (child protection). The compressor starts and then runs automatically. Note: When the setting is changed, the compressor does not start immediately if automatic defrosting is currently taking place. Goods to be refrigerated can be loaded immediately after switching on, because the storage temperature in the refrigerator is quickly reached. Note: From a food science point of view, +5 °C should be considered cold enough as a storage temperature. The following effects are of significance in respect of the interior tem- Perature: ­ Ambient temperature; ­ Quantity and temperature of the food stored; ­ Frequency with which the door is opened and how long it is left open. ⭠A defect in the appliance. The temperature regulator setting may therefore need to be adjusted to suit the specific conditions. 38°C Temperature controller position Range up to 1 Range about 3 Range about 3 3 to 5 Range about 3 These figures apply at ambient temperatures from +16°C to +38°C. If you want a higher or lower temperature, turn the temperature regulator to a warmer or cooler setting respectively. On hot summer days) and a cold setting on the temperature regulator (position"4" to "6") can cause the compressor to run continuously. Reason: when the ambient temperature is high, the compressor must run continuously to maintain the low temperature in the appliance. The fridge will not be able to defrost since automatic defrosting of the fridge is only possible when the compressor is not running (see also "Defrosting" section). the result is the build up of a thick layer of frost on the fridge rear wall. If this happens, turn the temperature regulator back to a warmer setting (position "3" to "5"). At this setting the compressor will be switched on and off as usual and automatic defrosting recommenced. [. . . ] Put the refrigerator back into operation. If you cannot find the remedy for a malfunction in these operating instructions, please contact your dealer or our customer service department. Addresses and telephone numbers are listed in the accompanying booklet "Guarantee Conditions/Customer Service Locations". Selective ordering of replacement parts can save unnecessary travel and costs. [. . . ]